1 files changed, 0 insertions, 65 deletions
diff --git a/Documentation/devicetree/bindings/gpio/snps-dwapb-gpio.txt b/Documentation/devicetree/bindings/gpio/snps-dwapb-gpio.txt
deleted file mode 100644
index 839dd32ffe11..000000000000
--- a/Documentation/devicetree/bindings/gpio/snps-dwapb-gpio.txt
+++ /dev/null
@@ -1,65 +0,0 @@
-* Synopsys DesignWare APB GPIO controller
-
-Required properties:
-- compatible : Should contain "snps,dw-apb-gpio"
-- reg : Address and length of the register set for the device.
-- #address-cells : should be 1 (for addressing port subnodes).
-- #size-cells : should be 0 (port subnodes).
-
-The GPIO controller has a configurable number of ports, each of which are
-represented as child nodes with the following properties:
-
-Required properties:
-- compatible : "snps,dw-apb-gpio-port"
-- gpio-controller : Marks the device node as a gpio controller.
-- #gpio-cells : Should be two.  The first cell is the pin number and
-  the second cell is used to specify the gpio polarity:
-      0 = active high
-      1 = active low
-- reg : The integer port index of the port, a single cell.
-
-Optional properties:
-- interrupt-controller : The first port may be configured to be an interrupt
-controller.
-- #interrupt-cells : Specifies the number of cells needed to encode an
-  interrupt.  Shall be set to 2.  The first cell defines the interrupt number,
-  the second encodes the triger flags encoded as described in
-  Documentation/devicetree/bindings/interrupt-controller/interrupts.txt
-- interrupts : The interrupts to the parent controller raised when GPIOs
-  generate the interrupts. If the controller provides one combined interrupt
-  for all GPIOs, specify a single interrupt. If the controller provides one
-  interrupt for each GPIO, provide a list of interrupts that correspond to each
-  of the GPIO pins. When specifying multiple interrupts, if any are unconnected,
-  use the interrupts-extended property to specify the interrupts and set the
-  interrupt controller handle for unused interrupts to 0.
-- snps,nr-gpios : The number of pins in the port, a single cell.
-- resets : Reset line for the controller.
-
-Example:
-
-gpio: gpio@20000 {
-	compatible = "snps,dw-apb-gpio";
-	reg = <0x20000 0x1000>;
-	#address-cells = <1>;
-	#size-cells = <0>;
-
-	porta: gpio@0 {
-		compatible = "snps,dw-apb-gpio-port";
-		gpio-controller;
-		#gpio-cells = <2>;
-		snps,nr-gpios = <8>;
-		reg = <0>;
-		interrupt-controller;
-		#interrupt-cells = <2>;
-		interrupt-parent = <&vic1>;
-		interrupts = <0>;
-	};
-
-	portb: gpio@1 {
-		compatible = "snps,dw-apb-gpio-port";
-		gpio-controller;
-		#gpio-cells = <2>;
-		snps,nr-gpios = <8>;
-		reg = <1>;
-	};
-};