diff options
Diffstat (limited to 'Documentation/blockdev/cciss.txt')
| -rw-r--r-- | Documentation/blockdev/cciss.txt | 15 |
1 files changed, 15 insertions, 0 deletions
diff --git a/Documentation/blockdev/cciss.txt b/Documentation/blockdev/cciss.txt index 89698e8df7d4..c00c6a5ab21f 100644 --- a/Documentation/blockdev/cciss.txt +++ b/Documentation/blockdev/cciss.txt @@ -169,3 +169,18 @@ is issued which positions the tape to a known position. Typically you must rewind the tape (by issuing "mt -f /dev/st0 rewind" for example) before i/o can proceed again to a tape drive which was reset. +There is a cciss_tape_cmds module parameter which can be used to make cciss +allocate more commands for use by tape drives. Ordinarily only a few commands +(6) are allocated for tape drives because tape drives are slow and +infrequently used and the primary purpose of Smart Array controllers is to +act as a RAID controller for disk drives, so the vast majority of commands +are allocated for disk devices. However, if you have more than a few tape +drives attached to a smart array, the default number of commands may not be +enought (for example, if you have 8 tape drives, you could only rewind 6 +at one time with the default number of commands.) The cciss_tape_cmds module +parameter allows more commands (up to 16 more) to be allocated for use by +tape drives. For example: + + insmod cciss.ko cciss_tape_cmds=16 + +Or, as a kernel boot parameter passed in via grub: cciss.cciss_tape_cmds=8 |