diff options
| -rw-r--r-- | drivers/bluetooth/btusb.c | 34 |
1 files changed, 30 insertions, 4 deletions
diff --git a/drivers/bluetooth/btusb.c b/drivers/bluetooth/btusb.c index 5cf0734eb31b..31d3febed187 100644 --- a/drivers/bluetooth/btusb.c +++ b/drivers/bluetooth/btusb.c @@ -435,6 +435,7 @@ static const struct dmi_system_id btusb_needs_reset_resume_table[] = { #define BTUSB_OOB_WAKE_ENABLED 11 #define BTUSB_HW_RESET_ACTIVE 12 #define BTUSB_TX_WAIT_VND_EVT 13 +#define BTUSB_WAKEUP_DISABLE 14 struct btusb_data { struct hci_dev *hdev; @@ -1175,6 +1176,13 @@ static int btusb_open(struct hci_dev *hdev) */ device_wakeup_enable(&data->udev->dev); + /* Disable device remote wakeup when host is suspended + * For Realtek chips, global suspend without + * SET_FEATURE (DEVICE_REMOTE_WAKEUP) can save more power in device. + */ + if (test_bit(BTUSB_WAKEUP_DISABLE, &data->flags)) + device_wakeup_disable(&data->udev->dev); + if (test_and_set_bit(BTUSB_INTR_RUNNING, &data->flags)) goto done; @@ -1238,6 +1246,11 @@ static int btusb_close(struct hci_dev *hdev) goto failed; data->intf->needs_remote_wakeup = 0; + + /* Enable remote wake up for auto-suspend */ + if (test_bit(BTUSB_WAKEUP_DISABLE, &data->flags)) + data->intf->needs_remote_wakeup = 1; + device_wakeup_disable(&data->udev->dev); usb_autopm_put_interface(data->intf); @@ -3771,11 +3784,11 @@ static int btusb_probe(struct usb_interface *intf, hdev->setup = btrtl_setup_realtek; hdev->shutdown = btrtl_shutdown_realtek; - /* Realtek devices lose their updated firmware over suspend, - * but the USB hub doesn't notice any status change. - * Explicitly request a device reset on resume. + /* Realtek devices lose their updated firmware over global + * suspend that means host doesn't send SET_FEATURE + * (DEVICE_REMOTE_WAKEUP) */ - interface_to_usbdev(intf)->quirks |= USB_QUIRK_RESET_RESUME; + set_bit(BTUSB_WAKEUP_DISABLE, &data->flags); } #endif @@ -3949,6 +3962,19 @@ static int btusb_suspend(struct usb_interface *intf, pm_message_t message) enable_irq(data->oob_wake_irq); } + /* For global suspend, Realtek devices lose the loaded fw + * in them. But for autosuspend, firmware should remain. + * Actually, it depends on whether the usb host sends + * set feature (enable wakeup) or not. + */ + if (test_bit(BTUSB_WAKEUP_DISABLE, &data->flags)) { + if (PMSG_IS_AUTO(message) && + device_can_wakeup(&data->udev->dev)) + data->udev->do_remote_wakeup = 1; + else if (!PMSG_IS_AUTO(message)) + data->udev->reset_resume = 1; + } + return 0; } |