diff options
| -rw-r--r-- | Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt | 31 |
1 files changed, 30 insertions, 1 deletions
diff --git a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt index 529e51879fb2..3381b9618b5b 100644 --- a/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt +++ b/Documentation/devicetree/bindings/usb/ci-hdrc-usb2.txt @@ -80,7 +80,10 @@ Optional properties: controller. It's expected that a mux state of 0 indicates device mode and a mux state of 1 indicates host mode. - mux-control-names: Shall be "usb_switch" if mux-controls is specified. -- pinctrl-names: Names for optional pin modes in "default", "host", "device" +- pinctrl-names: Names for optional pin modes in "default", "host", "device". + In case of HSIC-mode, "idle" and "active" pin modes are mandatory. In this + case, the "idle" state needs to pull down the data and strobe pin + and the "active" state needs to pull up the strobe pin. - pinctrl-n: alternate pin modes i.mx specific properties @@ -111,3 +114,29 @@ Example: mux-controls = <&usb_switch>; mux-control-names = "usb_switch"; }; + +Example for HSIC: + + usb@2184400 { + compatible = "fsl,imx6q-usb", "fsl,imx27-usb"; + reg = <0x02184400 0x200>; + interrupts = <0 41 IRQ_TYPE_LEVEL_HIGH>; + clocks = <&clks IMX6QDL_CLK_USBOH3>; + fsl,usbphy = <&usbphynop1>; + fsl,usbmisc = <&usbmisc 2>; + phy_type = "hsic"; + dr_mode = "host"; + ahb-burst-config = <0x0>; + tx-burst-size-dword = <0x10>; + rx-burst-size-dword = <0x10>; + pinctrl-names = "idle", "active"; + pinctrl-0 = <&pinctrl_usbh2_idle>; + pinctrl-1 = <&pinctrl_usbh2_active>; + #address-cells = <1>; + #size-cells = <0>; + + usbnet: smsc@1 { + compatible = "usb424,9730"; + reg = <1>; + }; + }; |