diff options
| -rw-r--r-- | drivers/gpio/Kconfig | 12 | ||||
| -rw-r--r-- | drivers/gpio/Makefile | 1 | ||||
| -rw-r--r-- | drivers/gpio/gpio-bd71828.c | 159 |
3 files changed, 172 insertions, 0 deletions
diff --git a/drivers/gpio/Kconfig b/drivers/gpio/Kconfig index 8adffd42f8cb..68adc1b94dda 100644 --- a/drivers/gpio/Kconfig +++ b/drivers/gpio/Kconfig @@ -1021,6 +1021,18 @@ config GPIO_BD70528 This driver can also be built as a module. If so, the module will be called gpio-bd70528. +config GPIO_BD71828 + tristate "ROHM BD71828 GPIO support" + depends on MFD_ROHM_BD71828 + help + Support for GPIOs on ROHM BD71828 PMIC. There are three GPIOs + available on the ROHM PMIC in total. The GPIOs are limited to + outputs only and pins must be configured to GPIO outputs by + OTP. Enable this only if you want to use these pins as outputs. + + This driver can also be built as a module. If so, the module + will be called gpio-bd71828. + config GPIO_BD9571MWV tristate "ROHM BD9571 GPIO support" depends on MFD_BD9571MWV diff --git a/drivers/gpio/Makefile b/drivers/gpio/Makefile index 34eb8b2b12dd..8629b81b5c17 100644 --- a/drivers/gpio/Makefile +++ b/drivers/gpio/Makefile @@ -37,6 +37,7 @@ obj-$(CONFIG_GPIO_ATH79) += gpio-ath79.o obj-$(CONFIG_GPIO_BCM_KONA) += gpio-bcm-kona.o obj-$(CONFIG_GPIO_BCM_XGS_IPROC) += gpio-xgs-iproc.o obj-$(CONFIG_GPIO_BD70528) += gpio-bd70528.o +obj-$(CONFIG_GPIO_BD71828) += gpio-bd71828.o obj-$(CONFIG_GPIO_BD9571MWV) += gpio-bd9571mwv.o obj-$(CONFIG_GPIO_BRCMSTB) += gpio-brcmstb.o obj-$(CONFIG_GPIO_BT8XX) += gpio-bt8xx.o diff --git a/drivers/gpio/gpio-bd71828.c b/drivers/gpio/gpio-bd71828.c new file mode 100644 index 000000000000..04aade9e0a4d --- /dev/null +++ b/drivers/gpio/gpio-bd71828.c @@ -0,0 +1,159 @@ +// SPDX-License-Identifier: GPL-2.0-only +// Copyright (C) 2018 ROHM Semiconductors + +#include <linux/gpio/driver.h> +#include <linux/mfd/rohm-bd71828.h> +#include <linux/module.h> +#include <linux/platform_device.h> +#include <linux/regmap.h> + +#define GPIO_OUT_REG(off) (BD71828_REG_GPIO_CTRL1 + (off)) +#define HALL_GPIO_OFFSET 3 + +/* + * These defines can be removed when + * "gpio: Add definition for GPIO direction" + * (9208b1e77d6e8e9776f34f46ef4079ecac9c3c25 in GPIO tree) gets merged, + */ +#ifndef GPIO_LINE_DIRECTION_IN + #define GPIO_LINE_DIRECTION_IN 1 + #define GPIO_LINE_DIRECTION_OUT 0 +#endif + +struct bd71828_gpio { + struct rohm_regmap_dev chip; + struct gpio_chip gpio; +}; + +static void bd71828_gpio_set(struct gpio_chip *chip, unsigned int offset, + int value) +{ + int ret; + struct bd71828_gpio *bdgpio = gpiochip_get_data(chip); + u8 val = (value) ? BD71828_GPIO_OUT_HI : BD71828_GPIO_OUT_LO; + + /* + * The HALL input pin can only be used as input. If this is the pin + * we are dealing with - then we are done + */ + if (offset == HALL_GPIO_OFFSET) + return; + + ret = regmap_update_bits(bdgpio->chip.regmap, GPIO_OUT_REG(offset), + BD71828_GPIO_OUT_MASK, val); + if (ret) + dev_err(bdgpio->chip.dev, "Could not set gpio to %d\n", value); +} + +static int bd71828_gpio_get(struct gpio_chip *chip, unsigned int offset) +{ + int ret; + unsigned int val; + struct bd71828_gpio *bdgpio = gpiochip_get_data(chip); + + if (offset == HALL_GPIO_OFFSET) + ret = regmap_read(bdgpio->chip.regmap, BD71828_REG_IO_STAT, + &val); + else + ret = regmap_read(bdgpio->chip.regmap, GPIO_OUT_REG(offset), + &val); + if (!ret) + ret = (val & BD71828_GPIO_OUT_MASK); + + return ret; +} + +static int bd71828_gpio_set_config(struct gpio_chip *chip, unsigned int offset, + unsigned long config) +{ + struct bd71828_gpio *bdgpio = gpiochip_get_data(chip); + + if (offset == HALL_GPIO_OFFSET) + return -ENOTSUPP; + + switch (pinconf_to_config_param(config)) { + case PIN_CONFIG_DRIVE_OPEN_DRAIN: + return regmap_update_bits(bdgpio->chip.regmap, + GPIO_OUT_REG(offset), + BD71828_GPIO_DRIVE_MASK, + BD71828_GPIO_OPEN_DRAIN); + case PIN_CONFIG_DRIVE_PUSH_PULL: + return regmap_update_bits(bdgpio->chip.regmap, + GPIO_OUT_REG(offset), + BD71828_GPIO_DRIVE_MASK, + BD71828_GPIO_PUSH_PULL); + default: + break; + } + return -ENOTSUPP; +} + +static int bd71828_get_direction(struct gpio_chip *chip, unsigned int offset) +{ + /* + * Pin usage is selected by OTP data. We can't read it runtime. Hence + * we trust that if the pin is not excluded by "gpio-reserved-ranges" + * the OTP configuration is set to OUT. (Other pins but HALL input pin + * on BD71828 can't really be used for general purpose input - input + * states are used for specific cases like regulator control or + * PMIC_ON_REQ. + */ + if (offset == HALL_GPIO_OFFSET) + return GPIO_LINE_DIRECTION_IN; + + return GPIO_LINE_DIRECTION_OUT; +} + +static int bd71828_probe(struct platform_device *pdev) +{ + struct bd71828_gpio *bdgpio; + struct rohm_regmap_dev *bd71828; + + bd71828 = dev_get_drvdata(pdev->dev.parent); + if (!bd71828) { + dev_err(&pdev->dev, "No MFD driver data\n"); + return -EINVAL; + } + + bdgpio = devm_kzalloc(&pdev->dev, sizeof(*bdgpio), + GFP_KERNEL); + if (!bdgpio) + return -ENOMEM; + + bdgpio->chip.dev = &pdev->dev; + bdgpio->gpio.parent = pdev->dev.parent; + bdgpio->gpio.label = "bd71828-gpio"; + bdgpio->gpio.owner = THIS_MODULE; + bdgpio->gpio.get_direction = bd71828_get_direction; + bdgpio->gpio.set_config = bd71828_gpio_set_config; + bdgpio->gpio.can_sleep = true; + bdgpio->gpio.get = bd71828_gpio_get; + bdgpio->gpio.set = bd71828_gpio_set; + bdgpio->gpio.base = -1; + + /* + * See if we need some implementation to mark some PINs as + * not controllable based on DT info or if core can handle + * "gpio-reserved-ranges" and exclude them from control + */ + bdgpio->gpio.ngpio = 4; + bdgpio->gpio.of_node = pdev->dev.parent->of_node; + bdgpio->chip.regmap = bd71828->regmap; + + return devm_gpiochip_add_data(&pdev->dev, &bdgpio->gpio, + bdgpio); +} + +static struct platform_driver bd71828_gpio = { + .driver = { + .name = "bd71828-gpio" + }, + .probe = bd71828_probe, +}; + +module_platform_driver(bd71828_gpio); + +MODULE_AUTHOR("Matti Vaittinen <matti.vaittinen@fi.rohmeurope.com>"); +MODULE_DESCRIPTION("BD71828 voltage regulator driver"); +MODULE_LICENSE("GPL"); +MODULE_ALIAS("platform:bd71828-gpio"); |