diff options
| -rw-r--r-- | drivers/mtd/nand/diskonchip.c | 38 |
1 files changed, 3 insertions, 35 deletions
diff --git a/drivers/mtd/nand/diskonchip.c b/drivers/mtd/nand/diskonchip.c index a5c046654233..4f4aa3555a6f 100644 --- a/drivers/mtd/nand/diskonchip.c +++ b/drivers/mtd/nand/diskonchip.c @@ -74,10 +74,6 @@ struct doc_priv { int (*late_init)(struct mtd_info *mtd); }; -/* This is the syndrome computed by the HW ecc generator upon reading an empty - page, one with all 0xff for data and stored ecc code. */ -static u_char empty_read_syndrome[6] = { 0x26, 0xff, 0x6d, 0x47, 0x73, 0x7a }; - /* This is the ecc value computed by the HW ecc generator upon writing an empty page, one with all 0xff for data. */ static u_char empty_write_ecc[6] = { 0x4b, 0x00, 0xe2, 0x0e, 0x93, 0xf7 }; @@ -912,7 +908,6 @@ static int doc200x_correct_data(struct mtd_info *mtd, u_char *dat, void __iomem *docptr = doc->virtadr; uint8_t calc_ecc[6]; volatile u_char dummy; - int emptymatch = 1; /* flush the pipeline */ if (DoC_is_2000(doc)) { @@ -936,37 +931,9 @@ static int doc200x_correct_data(struct mtd_info *mtd, u_char *dat, calc_ecc[i] = ReadDOC_(docptr, DoC_Mplus_ECCSyndrome0 + i); else calc_ecc[i] = ReadDOC_(docptr, DoC_ECCSyndrome0 + i); - if (calc_ecc[i] != empty_read_syndrome[i]) - emptymatch = 0; - } - /* If emptymatch=1, the read syndrome is consistent with an - all-0xff data and stored ecc block. Check the stored ecc. */ - if (emptymatch) { - for (i = 0; i < 6; i++) { - if (read_ecc[i] == 0xff) - continue; - emptymatch = 0; - break; - } } - /* If emptymatch still =1, check the data block. */ - if (emptymatch) { - /* Note: this somewhat expensive test should not be triggered - often. It could be optimized away by examining the data in - the readbuf routine, and remembering the result. */ - for (i = 0; i < 512; i++) { - if (dat[i] == 0xff) - continue; - emptymatch = 0; - break; - } - } - /* If emptymatch still =1, this is almost certainly a freshly- - erased block, in which case the ECC will not come out right. - We'll suppress the error and tell the caller everything's - OK. Because it is. */ - if (!emptymatch) - ret = doc_ecc_decode(rs_decoder, dat, calc_ecc); + + ret = doc_ecc_decode(rs_decoder, dat, calc_ecc); if (ret > 0) printk(KERN_ERR "doc200x_correct_data corrected %d errors\n", ret); } @@ -1586,6 +1553,7 @@ static int __init doc_probe(unsigned long physadr) nand->ecc.size = 512; nand->ecc.bytes = 6; nand->ecc.strength = 2; + nand->ecc.options = NAND_ECC_GENERIC_ERASED_CHECK; nand->bbt_options = NAND_BBT_USE_FLASH; /* Skip the automatic BBT scan so we can run it manually */ nand->options |= NAND_SKIP_BBTSCAN; |