diff options
| -rw-r--r-- | drivers/mmc/host/mmci.c | 13 | ||||
| -rw-r--r-- | include/linux/amba/mmci.h | 23 |
2 files changed, 34 insertions, 2 deletions
diff --git a/drivers/mmc/host/mmci.c b/drivers/mmc/host/mmci.c index 7e70c1a06d8a..ff115d920888 100644 --- a/drivers/mmc/host/mmci.c +++ b/drivers/mmc/host/mmci.c @@ -631,7 +631,18 @@ static int __devinit mmci_probe(struct amba_device *dev, struct amba_id *id) mmc->ops = &mmci_ops; mmc->f_min = (host->mclk + 511) / 512; - mmc->f_max = min(host->mclk, fmax); + /* + * If the platform data supplies a maximum operating + * frequency, this takes precedence. Else, we fall back + * to using the module parameter, which has a (low) + * default value in case it is not specified. Either + * value must not exceed the clock rate into the block, + * of course. + */ + if (plat->f_max) + mmc->f_max = min(host->mclk, plat->f_max); + else + mmc->f_max = min(host->mclk, fmax); dev_dbg(mmc_dev(mmc), "clocking block at %u Hz\n", mmc->f_max); #ifdef CONFIG_REGULATOR diff --git a/include/linux/amba/mmci.h b/include/linux/amba/mmci.h index 6b4241748dda..7e466fe72025 100644 --- a/include/linux/amba/mmci.h +++ b/include/linux/amba/mmci.h @@ -6,8 +6,29 @@ #include <linux/mmc/host.h> +/** + * struct mmci_platform_data - platform configuration for the MMCI + * (also known as PL180) block. + * @f_max: the maximum operational frequency for this host in this + * platform configuration. When this is specified it takes precedence + * over the module parameter for the same frequency. + * @ocr_mask: available voltages on the 4 pins from the block, this + * is ignored if a regulator is used, see the MMC_VDD_* masks in + * mmc/host.h + * @translate_vdd: a callback function to translate a MMC_VDD_* + * mask into a value to be binary or:ed and written into the + * MMCIPWR register of the block + * @status: if no GPIO read function was given to the block in + * gpio_wp (below) this function will be called to determine + * whether a card is present in the MMC slot or not + * @gpio_wp: read this GPIO pin to see if the card is write protected + * @gpio_cd: read this GPIO pin to detect card insertion + * @capabilities: the capabilities of the block as implemented in + * this platform, signify anything MMC_CAP_* from mmc/host.h + */ struct mmci_platform_data { - unsigned int ocr_mask; /* available voltages */ + unsigned int f_max; + unsigned int ocr_mask; u32 (*translate_vdd)(struct device *, unsigned int); unsigned int (*status)(struct device *); int gpio_wp; |