diff options
| -rw-r--r-- | drivers/regulator/tps65090-regulator.c | 155 |
1 files changed, 140 insertions, 15 deletions
diff --git a/drivers/regulator/tps65090-regulator.c b/drivers/regulator/tps65090-regulator.c index ca04e9f010e1..2057e2e311de 100644 --- a/drivers/regulator/tps65090-regulator.c +++ b/drivers/regulator/tps65090-regulator.c @@ -17,6 +17,7 @@ */ #include <linux/module.h> +#include <linux/delay.h> #include <linux/init.h> #include <linux/gpio.h> #include <linux/of_gpio.h> @@ -28,7 +29,13 @@ #include <linux/regulator/of_regulator.h> #include <linux/mfd/tps65090.h> +#define MAX_CTRL_READ_TRIES 5 +#define MAX_FET_ENABLE_TRIES 1000 + +#define CTRL_EN_BIT 0 /* Regulator enable bit, active high */ #define CTRL_WT_BIT 2 /* Regulator wait time 0 bit */ +#define CTRL_PG_BIT 4 /* Regulator power good bit, 1=good */ +#define CTRL_TO_BIT 7 /* Regulator timeout bit, 1=wait */ #define MAX_OVERCURRENT_WAIT 3 /* Overcurrent wait must be <= this */ @@ -80,40 +87,158 @@ static int tps65090_reg_set_overcurrent_wait(struct tps65090_regulator *ri, return ret; } -static struct regulator_ops tps65090_reg_contol_ops = { +/** + * tps65090_try_enable_fet - Try to enable a FET + * + * @rdev: Regulator device + * + * Return: 0 if ok, -ENOTRECOVERABLE if the FET power good bit did not get + * set, or some other -ve value if another error occurred (e.g. i2c error) + */ +static int tps65090_try_enable_fet(struct regulator_dev *rdev) +{ + unsigned int control; + int ret, i; + + ret = regmap_update_bits(rdev->regmap, rdev->desc->enable_reg, + rdev->desc->enable_mask, + rdev->desc->enable_mask); + if (ret < 0) { + dev_err(&rdev->dev, "Error in updating reg %#x\n", + rdev->desc->enable_reg); + return ret; + } + + for (i = 0; i < MAX_CTRL_READ_TRIES; i++) { + ret = regmap_read(rdev->regmap, rdev->desc->enable_reg, + &control); + if (ret < 0) + return ret; + + if (!(control & BIT(CTRL_TO_BIT))) + break; + + usleep_range(1000, 1500); + } + if (!(control & BIT(CTRL_PG_BIT))) + return -ENOTRECOVERABLE; + + return 0; +} + +/** + * tps65090_fet_enable - Enable a FET, trying a few times if it fails + * + * Some versions of the tps65090 have issues when turning on the FETs. + * This function goes through several steps to ensure the best chance of the + * FET going on. Specifically: + * - We'll make sure that we bump the "overcurrent wait" to the maximum, which + * increases the chances that we'll turn on properly. + * - We'll retry turning the FET on multiple times (turning off in between). + * + * @rdev: Regulator device + * + * Return: 0 if ok, non-zero if it fails. + */ +static int tps65090_fet_enable(struct regulator_dev *rdev) +{ + int ret, tries; + + /* + * Try enabling multiple times until we succeed since sometimes the + * first try times out. + */ + tries = 0; + while (true) { + ret = tps65090_try_enable_fet(rdev); + if (!ret) + break; + if (ret != -ENOTRECOVERABLE || tries == MAX_FET_ENABLE_TRIES) + goto err; + + /* Try turning the FET off (and then on again) */ + ret = regmap_update_bits(rdev->regmap, rdev->desc->enable_reg, + rdev->desc->enable_mask, 0); + if (ret) + goto err; + + tries++; + } + + if (tries) + dev_warn(&rdev->dev, "reg %#x enable ok after %d tries\n", + rdev->desc->enable_reg, tries); + + return 0; +err: + dev_warn(&rdev->dev, "reg %#x enable failed\n", rdev->desc->enable_reg); + WARN_ON(1); + + return ret; +} + +static struct regulator_ops tps65090_reg_control_ops = { .enable = regulator_enable_regmap, .disable = regulator_disable_regmap, .is_enabled = regulator_is_enabled_regmap, }; +static struct regulator_ops tps65090_fet_control_ops = { + .enable = tps65090_fet_enable, + .disable = regulator_disable_regmap, + .is_enabled = regulator_is_enabled_regmap, +}; + static struct regulator_ops tps65090_ldo_ops = { }; -#define tps65090_REG_DESC(_id, _sname, _en_reg, _ops) \ +#define tps65090_REG_DESC(_id, _sname, _en_reg, _en_bits, _ops) \ { \ .name = "TPS65090_RAILS"#_id, \ .supply_name = _sname, \ .id = TPS65090_REGULATOR_##_id, \ .ops = &_ops, \ .enable_reg = _en_reg, \ - .enable_mask = BIT(0), \ + .enable_val = _en_bits, \ + .enable_mask = _en_bits, \ .type = REGULATOR_VOLTAGE, \ .owner = THIS_MODULE, \ } static struct regulator_desc tps65090_regulator_desc[] = { - tps65090_REG_DESC(DCDC1, "vsys1", 0x0C, tps65090_reg_contol_ops), - tps65090_REG_DESC(DCDC2, "vsys2", 0x0D, tps65090_reg_contol_ops), - tps65090_REG_DESC(DCDC3, "vsys3", 0x0E, tps65090_reg_contol_ops), - tps65090_REG_DESC(FET1, "infet1", 0x0F, tps65090_reg_contol_ops), - tps65090_REG_DESC(FET2, "infet2", 0x10, tps65090_reg_contol_ops), - tps65090_REG_DESC(FET3, "infet3", 0x11, tps65090_reg_contol_ops), - tps65090_REG_DESC(FET4, "infet4", 0x12, tps65090_reg_contol_ops), - tps65090_REG_DESC(FET5, "infet5", 0x13, tps65090_reg_contol_ops), - tps65090_REG_DESC(FET6, "infet6", 0x14, tps65090_reg_contol_ops), - tps65090_REG_DESC(FET7, "infet7", 0x15, tps65090_reg_contol_ops), - tps65090_REG_DESC(LDO1, "vsys-l1", 0, tps65090_ldo_ops), - tps65090_REG_DESC(LDO2, "vsys-l2", 0, tps65090_ldo_ops), + tps65090_REG_DESC(DCDC1, "vsys1", 0x0C, BIT(CTRL_EN_BIT), + tps65090_reg_control_ops), + tps65090_REG_DESC(DCDC2, "vsys2", 0x0D, BIT(CTRL_EN_BIT), + tps65090_reg_control_ops), + tps65090_REG_DESC(DCDC3, "vsys3", 0x0E, BIT(CTRL_EN_BIT), + tps65090_reg_control_ops), + + tps65090_REG_DESC(FET1, "infet1", 0x0F, + BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT), + tps65090_fet_control_ops), + tps65090_REG_DESC(FET2, "infet2", 0x10, + BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT), + tps65090_fet_control_ops), + tps65090_REG_DESC(FET3, "infet3", 0x11, + BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT), + tps65090_fet_control_ops), + tps65090_REG_DESC(FET4, "infet4", 0x12, + BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT), + tps65090_fet_control_ops), + tps65090_REG_DESC(FET5, "infet5", 0x13, + BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT), + tps65090_fet_control_ops), + tps65090_REG_DESC(FET6, "infet6", 0x14, + BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT), + tps65090_fet_control_ops), + tps65090_REG_DESC(FET7, "infet7", 0x15, + BIT(CTRL_EN_BIT) | BIT(CTRL_PG_BIT), + tps65090_fet_control_ops), + + tps65090_REG_DESC(LDO1, "vsys-l1", 0, 0, + tps65090_ldo_ops), + tps65090_REG_DESC(LDO2, "vsys-l2", 0, 0, + tps65090_ldo_ops), }; static inline bool is_dcdc(int id) |