Merge tag 'sound-5.17-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound

Pull sound updates from Takashi Iwai:
 "It's a relatively calm development cycle, but still lots of updates in
  the driver side like Intel SOF. Below are some highlights:

  ALSA / ASoC core:
   - A new kselftest for ALSA control API
   - PCM NO_REWINDS support
   - Potential race fixes around control removals
   - Unify x86 SG-buffer memory allocation code
   - Cleanups and race fixes for ASoC DPCM locking

  ASoC:
   - Refinements and cleanups around the delay() APIs
   - Wider use of dev_err_probe().
   - Continuing cleanups and improvements to the SOF code
   - Support for pin switches in simple-card derived cards
   - Support for AMD Renoir ACP, Asahi Kasei Microdevices AKM4375, Intel
     systems using NAU8825 and MAX98390, Mediatek MT8915, nVidia Tegra20
     S/PDIF, Qualcomm systems using ALC5682I-VS and Texas Instruments
     TLV320ADC3xxx

  HD-audio / USB-audio:
   - Fix deadlock at HD-audio codec unbinding
   - Fixes for Tegra194 HD-audio, new HDA support for CS35L41 codec
   - Quirks for Lenovo and HP machines, Gigabyte mobo, Bose device

  Misc:
   - Fix virmidi drain behavior

  Note that the merge of CS35L41 codec support is still half-baked, and
  at least one ACPI change is missing. Although this won't hinder the
  kernel build itself, we're going to catch up before RC1"

* tag 'sound-5.17-rc1' of git://git.kernel.org/pub/scm/linux/kernel/git/tiwai/sound: (415 commits)
  ALSA: hda: intel-dsp-config: reorder the config table
  ALSA: hda: intel-dsp-config: add JasperLake support
  ALSA: hda: cs35l41: fix double free on error in probe()
  ALSA: hda: Fix dependencies of CS35L41 on SPI/I2C buses
  ALSA: hda: Fix dependency on ASoC cs35l41 codec
  ASoC: cs35l41: Add support for hibernate memory retention mode
  ASoC: cs35l41: Update handling of test key registers
  ALSA: intel_hdmi: Check for error num after setting mask
  ASoC: wcd9335: Keep a RX port value for each SLIM RX mux
  ASoC: amd: acp: acp-mach: Change default RT1019 amp dev id
  ALSA: virmidi: Remove duplicated code
  ALSA: seq: virmidi: Add a drain operation
  ASoC: topology: Fix typo
  ASoC: fsl_asrc: refine the check of available clock divider
  ASoC: Intel: bytcr_rt5640: Add support for external GPIO jack-detect
  ASoC: Intel: bytcr_rt5640: Support retrieving the codec IRQ from the AMCR0F28 ACPI dev
  ASoC: rt5640: Add support for boards with an external jack-detect GPIO
  ASoC: rt5640: Allow snd_soc_component_set_jack() to override the codec IRQ
  ASoC: rt5640: Change jack_work to a delayed_work
  ASoC: rt5640: Fix possible NULL pointer deref on resume
  ...

1 files changed, 12 insertions, 2 deletions

diff --git a/drivers/mtd/nand/raw/qcom_nandc.c b/drivers/mtd/nand/raw/qcom_nandc.c
index 04e6f7b26706..7c6efa3b6255 100644
--- a/drivers/mtd/nand/raw/qcom_nandc.c
+++ b/drivers/mtd/nand/raw/qcom_nandc.c
@@ -6,6 +6,7 @@
 #include <linux/clk.h>
 #include <linux/slab.h>
 #include <linux/bitops.h>
+#include <linux/dma/qcom_adm.h>
 #include <linux/dma-mapping.h>
 #include <linux/dmaengine.h>
 #include <linux/module.h>
@@ -952,6 +953,7 @@ static int prep_adm_dma_desc(struct qcom_nand_controller *nandc, bool read,
 	struct dma_async_tx_descriptor *dma_desc;
 	struct scatterlist *sgl;
 	struct dma_slave_config slave_conf;
+	struct qcom_adm_peripheral_config periph_conf = {};
 	enum dma_transfer_direction dir_eng;
 	int ret;
 
@@ -983,11 +985,19 @@ static int prep_adm_dma_desc(struct qcom_nand_controller *nandc, bool read,
 	if (read) {
 		slave_conf.src_maxburst = 16;
 		slave_conf.src_addr = nandc->base_dma + reg_off;
-		slave_conf.slave_id = nandc->data_crci;
+		if (nandc->data_crci) {
+			periph_conf.crci = nandc->data_crci;
+			slave_conf.peripheral_config = &periph_conf;
+			slave_conf.peripheral_size = sizeof(periph_conf);
+		}
 	} else {
 		slave_conf.dst_maxburst = 16;
 		slave_conf.dst_addr = nandc->base_dma + reg_off;
-		slave_conf.slave_id = nandc->cmd_crci;
+		if (nandc->cmd_crci) {
+			periph_conf.crci = nandc->cmd_crci;
+			slave_conf.peripheral_config = &periph_conf;
+			slave_conf.peripheral_size = sizeof(periph_conf);
+		}
 	}
 
 	ret = dmaengine_slave_config(nandc->chan, &slave_conf);