diff options
author | Shaohua Li <shli@kernel.org> | 2012-10-11 13:49:05 +1100 |
---|---|---|
committer | NeilBrown <neilb@suse.de> | 2012-10-11 13:49:05 +1100 |
commit | 620125f2bf8ff0c4969b79653b54d7bcc9d40637 (patch) | |
tree | 373257b7e9a236e66bc3ad99cd1d158e7430014e /drivers/md/raid5.c | |
parent | 582e2e056a5c3410174c23f5134e6b00e0db9101 (diff) | |
download | linux-620125f2bf8ff0c4969b79653b54d7bcc9d40637.tar.bz2 |
MD: raid5 trim support
Discard for raid4/5/6 has limitation. If discard request size is
small, we do discard for one disk, but we need calculate parity and
write parity disk. To correctly calculate parity, zero_after_discard
must be guaranteed. Even it's true, we need do discard for one disk
but write another disks, which makes the parity disks wear out
fast. This doesn't make sense. So an efficient discard for raid4/5/6
should discard all data disks and parity disks, which requires the
write pattern to be (A, A+chunk_size, A+chunk_size*2...). If A's size
is smaller than chunk_size, such pattern is almost impossible in
practice. So in this patch, I only handle the case that A's size
equals to chunk_size. That is discard request should be aligned to
stripe size and its size is multiple of stripe size.
Since we can only handle request with specific alignment and size (or
part of the request fitting stripes), we can't guarantee
zero_after_discard even zero_after_discard is true in low level
drives.
The block layer doesn't send down correctly aligned requests even
correct discard alignment is set, so I must filter out.
For raid4/5/6 parity calculation, if data is 0, parity is 0. So if
zero_after_discard is true for all disks, data is consistent after
discard. Otherwise, data might be lost. Let's consider a scenario:
discard a stripe, write data to one disk and write parity disk. The
stripe could be still inconsistent till then depending on using data
from other data disks or parity disks to calculate new parity. If the
disk is broken, we can't restore it. So in this patch, we only enable
discard support if all disks have zero_after_discard.
If discard fails in one disk, we face the similar inconsistent issue
above. The patch will make discard follow the same path as normal
write request. If discard fails, a resync will be scheduled to make
the data consistent. This isn't good to have extra writes, but data
consistency is important.
If a subsequent read/write request hits raid5 cache of a discarded
stripe, the discarded dev page should have zero filled, so the data is
consistent. This patch will always zero dev page for discarded request
stripe. This isn't optimal because discard request doesn't need such
payload. Next patch will avoid it.
Signed-off-by: Shaohua Li <shli@fusionio.com>
Signed-off-by: NeilBrown <neilb@suse.de>
Diffstat (limited to 'drivers/md/raid5.c')
-rw-r--r-- | drivers/md/raid5.c | 168 |
1 files changed, 165 insertions, 3 deletions
diff --git a/drivers/md/raid5.c b/drivers/md/raid5.c index 81c02d63440b..74dcf19cfe68 100644 --- a/drivers/md/raid5.c +++ b/drivers/md/raid5.c @@ -547,6 +547,8 @@ static void ops_run_io(struct stripe_head *sh, struct stripe_head_state *s) rw = WRITE_FUA; else rw = WRITE; + if (test_and_clear_bit(R5_Discard, &sh->dev[i].flags)) + rw |= REQ_DISCARD; } else if (test_and_clear_bit(R5_Wantread, &sh->dev[i].flags)) rw = READ; else if (test_and_clear_bit(R5_WantReplace, @@ -1170,8 +1172,13 @@ ops_run_biodrain(struct stripe_head *sh, struct dma_async_tx_descriptor *tx) set_bit(R5_WantFUA, &dev->flags); if (wbi->bi_rw & REQ_SYNC) set_bit(R5_SyncIO, &dev->flags); - tx = async_copy_data(1, wbi, dev->page, - dev->sector, tx); + if (wbi->bi_rw & REQ_DISCARD) { + memset(page_address(dev->page), 0, + STRIPE_SECTORS << 9); + set_bit(R5_Discard, &dev->flags); + } else + tx = async_copy_data(1, wbi, dev->page, + dev->sector, tx); wbi = r5_next_bio(wbi, dev->sector); } } @@ -1237,6 +1244,20 @@ ops_run_reconstruct5(struct stripe_head *sh, struct raid5_percpu *percpu, pr_debug("%s: stripe %llu\n", __func__, (unsigned long long)sh->sector); + for (i = 0; i < sh->disks; i++) { + if (pd_idx == i) + continue; + if (!test_bit(R5_Discard, &sh->dev[i].flags)) + break; + } + if (i >= sh->disks) { + atomic_inc(&sh->count); + memset(page_address(sh->dev[pd_idx].page), 0, + STRIPE_SECTORS << 9); + set_bit(R5_Discard, &sh->dev[pd_idx].flags); + ops_complete_reconstruct(sh); + return; + } /* check if prexor is active which means only process blocks * that are part of a read-modify-write (written) */ @@ -1281,10 +1302,28 @@ ops_run_reconstruct6(struct stripe_head *sh, struct raid5_percpu *percpu, { struct async_submit_ctl submit; struct page **blocks = percpu->scribble; - int count; + int count, i; pr_debug("%s: stripe %llu\n", __func__, (unsigned long long)sh->sector); + for (i = 0; i < sh->disks; i++) { + if (sh->pd_idx == i || sh->qd_idx == i) + continue; + if (!test_bit(R5_Discard, &sh->dev[i].flags)) + break; + } + if (i >= sh->disks) { + atomic_inc(&sh->count); + memset(page_address(sh->dev[sh->pd_idx].page), 0, + STRIPE_SECTORS << 9); + memset(page_address(sh->dev[sh->qd_idx].page), 0, + STRIPE_SECTORS << 9); + set_bit(R5_Discard, &sh->dev[sh->pd_idx].flags); + set_bit(R5_Discard, &sh->dev[sh->qd_idx].flags); + ops_complete_reconstruct(sh); + return; + } + count = set_syndrome_sources(blocks, sh); atomic_inc(&sh->count); @@ -4067,6 +4106,88 @@ static void release_stripe_plug(struct mddev *mddev, release_stripe(sh); } +static void make_discard_request(struct mddev *mddev, struct bio *bi) +{ + struct r5conf *conf = mddev->private; + sector_t logical_sector, last_sector; + struct stripe_head *sh; + int remaining; + int stripe_sectors; + + if (mddev->reshape_position != MaxSector) + /* Skip discard while reshape is happening */ + return; + + logical_sector = bi->bi_sector & ~((sector_t)STRIPE_SECTORS-1); + last_sector = bi->bi_sector + (bi->bi_size>>9); + + bi->bi_next = NULL; + bi->bi_phys_segments = 1; /* over-loaded to count active stripes */ + + stripe_sectors = conf->chunk_sectors * + (conf->raid_disks - conf->max_degraded); + logical_sector = DIV_ROUND_UP_SECTOR_T(logical_sector, + stripe_sectors); + sector_div(last_sector, stripe_sectors); + + logical_sector *= conf->chunk_sectors; + last_sector *= conf->chunk_sectors; + + for (; logical_sector < last_sector; + logical_sector += STRIPE_SECTORS) { + DEFINE_WAIT(w); + int d; + again: + sh = get_active_stripe(conf, logical_sector, 0, 0, 0); + prepare_to_wait(&conf->wait_for_overlap, &w, + TASK_UNINTERRUPTIBLE); + spin_lock_irq(&sh->stripe_lock); + for (d = 0; d < conf->raid_disks; d++) { + if (d == sh->pd_idx || d == sh->qd_idx) + continue; + if (sh->dev[d].towrite || sh->dev[d].toread) { + set_bit(R5_Overlap, &sh->dev[d].flags); + spin_unlock_irq(&sh->stripe_lock); + release_stripe(sh); + schedule(); + goto again; + } + } + finish_wait(&conf->wait_for_overlap, &w); + for (d = 0; d < conf->raid_disks; d++) { + if (d == sh->pd_idx || d == sh->qd_idx) + continue; + sh->dev[d].towrite = bi; + set_bit(R5_OVERWRITE, &sh->dev[d].flags); + raid5_inc_bi_active_stripes(bi); + } + spin_unlock_irq(&sh->stripe_lock); + if (conf->mddev->bitmap) { + for (d = 0; + d < conf->raid_disks - conf->max_degraded; + d++) + bitmap_startwrite(mddev->bitmap, + sh->sector, + STRIPE_SECTORS, + 0); + sh->bm_seq = conf->seq_flush + 1; + set_bit(STRIPE_BIT_DELAY, &sh->state); + } + + set_bit(STRIPE_HANDLE, &sh->state); + clear_bit(STRIPE_DELAYED, &sh->state); + if (!test_and_set_bit(STRIPE_PREREAD_ACTIVE, &sh->state)) + atomic_inc(&conf->preread_active_stripes); + release_stripe_plug(mddev, sh); + } + + remaining = raid5_dec_bi_active_stripes(bi); + if (remaining == 0) { + md_write_end(mddev); + bio_endio(bi, 0); + } +} + static void make_request(struct mddev *mddev, struct bio * bi) { struct r5conf *conf = mddev->private; @@ -4089,6 +4210,11 @@ static void make_request(struct mddev *mddev, struct bio * bi) chunk_aligned_read(mddev,bi)) return; + if (unlikely(bi->bi_rw & REQ_DISCARD)) { + make_discard_request(mddev, bi); + return; + } + logical_sector = bi->bi_sector & ~((sector_t)STRIPE_SECTORS-1); last_sector = bi->bi_sector + (bi->bi_size>>9); bi->bi_next = NULL; @@ -5362,6 +5488,7 @@ static int run(struct mddev *mddev) if (mddev->queue) { int chunk_size; + bool discard_supported = true; /* read-ahead size must cover two whole stripes, which * is 2 * (datadisks) * chunksize where 'n' is the * number of raid devices @@ -5381,13 +5508,48 @@ static int run(struct mddev *mddev) blk_queue_io_min(mddev->queue, chunk_size); blk_queue_io_opt(mddev->queue, chunk_size * (conf->raid_disks - conf->max_degraded)); + /* + * We can only discard a whole stripe. It doesn't make sense to + * discard data disk but write parity disk + */ + stripe = stripe * PAGE_SIZE; + mddev->queue->limits.discard_alignment = stripe; + mddev->queue->limits.discard_granularity = stripe; + /* + * unaligned part of discard request will be ignored, so can't + * guarantee discard_zerors_data + */ + mddev->queue->limits.discard_zeroes_data = 0; rdev_for_each(rdev, mddev) { disk_stack_limits(mddev->gendisk, rdev->bdev, rdev->data_offset << 9); disk_stack_limits(mddev->gendisk, rdev->bdev, rdev->new_data_offset << 9); + /* + * discard_zeroes_data is required, otherwise data + * could be lost. Consider a scenario: discard a stripe + * (the stripe could be inconsistent if + * discard_zeroes_data is 0); write one disk of the + * stripe (the stripe could be inconsistent again + * depending on which disks are used to calculate + * parity); the disk is broken; The stripe data of this + * disk is lost. + */ + if (!blk_queue_discard(bdev_get_queue(rdev->bdev)) || + !bdev_get_queue(rdev->bdev)-> + limits.discard_zeroes_data) + discard_supported = false; } + + if (discard_supported && + mddev->queue->limits.max_discard_sectors >= stripe && + mddev->queue->limits.discard_granularity >= stripe) + queue_flag_set_unlocked(QUEUE_FLAG_DISCARD, + mddev->queue); + else + queue_flag_clear_unlocked(QUEUE_FLAG_DISCARD, + mddev->queue); } return 0; |