Merge branch 'remotes/lorenzo/pci/tegra'

  - Reorganize Tegra AFI/PHY/REFCLK/etc functions (Manikanta Maddireddy)

  - Mask Tegra AFI_INTR in runtime suspend (Manikanta Maddireddy)

  - Fix Tegra AFI/PCIe powerup sequence (Manikanta Maddireddy)

  - Add Tegra124, Tegra132, Tegra210, and Tegra186 support for Gen2 link
    speed (Manikanta Maddireddy)

  - Advertise Tegra AER support (Manikanta Maddireddy)

  - Program Tegra210 UPHY settings (Manikanta Maddireddy)

  - Enable Tegra opportunistic UpdateFC and ACK (Manikanta Maddireddy)

  - Disable Tegra AFI dynamic clock gating (Manikanta Maddireddy)

  - Process Tegra pending DLL transactions before entering L1 or L2 to
    prevent receiver errors (Manikanta Maddireddy)

  - Enable Tegra xclk clock clamping in L1 (Manikanta Maddireddy)

  - Increase Tegra deskew retry time (Manikanta Maddireddy)

  - Work around Tegra hardware RAW erratum (Manikanta Maddireddy)

  - Update Tegra210 flow control timer frequency (Manikanta Maddireddy)

  - Work around Tegra Gen1/Gen2 link number negotiation issue (Manikanta
    Maddireddy)

  - Work around Tegra PLLE power down issue (Manikanta Maddireddy)

  - Program Tegra20 to support cacheable upstream transactions (Manikanta
    Maddireddy)

  - Log Tegra PRSNT_SENSE_IRQ as debug, not err (Manikanta Maddireddy)

  - Add register offset for third Root Port on Tegra186 and Tegra30
    (Manikanta Maddireddy)

  - Document Tegra PCIe DPD pinctrl property (Manikanta Maddireddy)

  - Put Tegra PEX CLK & BIAS pads in DPD mode to reduce power usage when
    powergated (Manikanta Maddireddy)

  - Add generic DT binding for "reset-gpios" property (Manikanta
    Maddireddy)

  - Add Tegra support for GPIO-based PERST# (Manikanta Maddireddy)

  - Enable Relaxed Ordering only for Tegra20 & Tegra30 (Vidya Sagar)

* remotes/lorenzo/pci/tegra:
  PCI: tegra: Enable Relaxed Ordering only for Tegra20 & Tegra30
  PCI: tegra: Change link retry log level to debug
  PCI: tegra: Add support for GPIO based PERST#
  PCI: Add DT binding for "reset-gpios" property
  PCI: tegra: Put PEX CLK & BIAS pads in DPD mode
  dt-bindings: pci: tegra: Document PCIe DPD pinctrl optional prop
  PCI: tegra: Add AFI_PEX2_CTRL reg offset as part of SoC struct
  PCI: tegra: Change PRSNT_SENSE IRQ log to debug
  PCI: tegra: Program AFI_CACHE_BAR_{0,1}_{ST,SZ} registers only for Tegra20
  PCI: tegra: Fix PLLE power down issue due to CLKREQ# signal
  PCI: tegra: Set target speed as Gen1 before starting LTSSM
  PCI: tegra: Update flow control timer frequency in Tegra210
  PCI: tegra: Add SW fixup for RAW violations
  PCI: tegra: Increase the deskew retry time
  PCI: tegra: Enable PCIe xclk clock clamping
  PCI: tegra: Process pending DLL transactions before entering L1 or L2
  PCI: tegra: Disable AFI dynamic clock gating
  PCI: tegra: Enable opportunistic UpdateFC and ACK
  PCI: tegra: Program UPHY electrical settings for Tegra210
  PCI: tegra: Advertise PCIe Advanced Error Reporting (AER) capability
  PCI: tegra: Add PCIe Gen2 link speed support
  PCI: tegra: Fix PCIe host power up sequence
  PCI: tegra: Mask AFI_INTR in runtime suspend
  PCI: tegra: Rearrange Tegra PCIe driver functions
  PCI: tegra: Handle failure cases in tegra_pcie_power_on()
  soc/tegra: pmc: Export tegra_powergate_power_on()

2 files changed, 11 insertions, 0 deletions

diff --git a/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt b/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt
index 145a4f04194f..7939bca47861 100644
--- a/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt
+++ b/Documentation/devicetree/bindings/pci/nvidia,tegra20-pcie.txt
@@ -65,6 +65,14 @@ Required properties:
   - afi
   - pcie_x
 
+Optional properties:
+- pinctrl-names: A list of pinctrl state names. Must contain the following
+  entries:
+  - "default": active state, puts PCIe I/O out of deep power down state
+  - "idle": puts PCIe I/O into deep power down state
+- pinctrl-0: phandle for the default/active state of pin configurations.
+- pinctrl-1: phandle for the idle state of pin configurations.
+
 Required properties on Tegra124 and later (deprecated):
 - phys: Must contain an entry for each entry in phy-names.
 - phy-names: Must include the following entries:
diff --git a/Documentation/devicetree/bindings/pci/pci.txt b/Documentation/devicetree/bindings/pci/pci.txt
index 92c01db610df..2a5d91024059 100644
--- a/Documentation/devicetree/bindings/pci/pci.txt
+++ b/Documentation/devicetree/bindings/pci/pci.txt
@@ -24,6 +24,9 @@ driver implementation may support the following properties:
    unsupported link speed, for instance, trying to do training for
    unsupported link speed, etc.  Must be '4' for gen4, '3' for gen3, '2'
    for gen2, and '1' for gen1. Any other values are invalid.
+- reset-gpios:
+   If present this property specifies PERST# GPIO. Host drivers can parse the
+   GPIO and apply fundamental reset to endpoints.
 
 PCI-PCI Bridge properties
 -------------------------