summaryrefslogtreecommitdiffstats
path: root/Documentation/usb
diff options
context:
space:
mode:
authorH. Nikolaus Schaller <hns@goldelico.com>2015-04-20 22:15:20 +0200
committerJonathan Corbet <corbet@lwn.net>2015-05-07 09:44:04 -0600
commite3aa205aa131d9b6452c51191dae0aac8e6f1fbd (patch)
treea756eaefce561ef9aef96e53340dcf0d210e728c /Documentation/usb
parent4ae711f4a37bff6cf501b48d58f9e28b031b02c9 (diff)
downloadlinux-e3aa205aa131d9b6452c51191dae0aac8e6f1fbd.tar.bz2
Documentation usb serial: fixed how to provide vendor and product id
While trying to test a Cinterion GSM/GPS/3G module I had reconfigured the USB interface by mistake and therefore needed to run a different USB driver than CDC-ACM. It turned out that I need the "usbserial" driver. This file is an official description how to use it: Documentation/usb/usb-serial.txt But it is outdated. The parameters vendor= and product= have been superseded by a /sys interface. Here was the solution: https://bbs.archlinux.org/viewtopic.php?id=175499 insmod usbserial vendor=0x#### product=0x#### becomes (first #### is vendor, second is product) modprobe usbserial echo #### #### >/sys/bus/usb-serial/drivers/generic/new_id This patch changes the documentation file to describe the modern variant. Please note that the old one still works (if compiled as module). Signed-off-by: H. Nikolaus Schaller <hns@goldelico.com> Signed-off-by: Marek Belisko <marek@goldelico.com> Signed-off-by: Jonathan Corbet <corbet@lwn.net>
Diffstat (limited to 'Documentation/usb')
-rw-r--r--Documentation/usb/usb-serial.txt12
1 files changed, 7 insertions, 5 deletions
diff --git a/Documentation/usb/usb-serial.txt b/Documentation/usb/usb-serial.txt
index 947fa62bccf2..349f3104fa4f 100644
--- a/Documentation/usb/usb-serial.txt
+++ b/Documentation/usb/usb-serial.txt
@@ -465,12 +465,14 @@ Generic Serial driver
device, and does not support any kind of device flow control. All that
is required of your device is that it has at least one bulk in endpoint,
or one bulk out endpoint.
-
- To enable the generic driver to recognize your device, build the driver
- as a module and load it by the following invocation:
+
+ To enable the generic driver to recognize your device, provide
+ echo <vid> <pid> >/sys/bus/usb-serial/drivers/generic/new_id
+ where the <vid> and <pid> is replaced with the hex representation of your
+ device's vendor id and product id.
+ If the driver is compiled as a module you can also provide one id when
+ loading the module
insmod usbserial vendor=0x#### product=0x####
- where the #### is replaced with the hex representation of your device's
- vendor id and product id.
This driver has been successfully used to connect to the NetChip USB
development board, providing a way to develop USB firmware without