Merge git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next

Pull networking updates from David Miller:
 "Another merge window, another set of networking changes.  I've heard
  rumblings that the lightweight tunnels infrastructure has been voted
  networking change of the year.  But what do I know?

   1) Add conntrack support to openvswitch, from Joe Stringer.

   2) Initial support for VRF (Virtual Routing and Forwarding), which
      allows the segmentation of routing paths without using multiple
      devices.  There are some semantic kinks to work out still, but
      this is a reasonably strong foundation.  From David Ahern.

   3) Remove spinlock fro act_bpf fast path, from Alexei Starovoitov.

   4) Ignore route nexthops with a link down state in ipv6, just like
      ipv4.  From Andy Gospodarek.

   5) Remove spinlock from fast path of act_gact and act_mirred, from
      Eric Dumazet.

   6) Document the DSA layer, from Florian Fainelli.

   7) Add netconsole support to bcmgenet, systemport, and DSA.  Also
      from Florian Fainelli.

   8) Add Mellanox Switch Driver and core infrastructure, from Jiri
      Pirko.

   9) Add support for "light weight tunnels", which allow for
      encapsulation and decapsulation without bearing the overhead of a
      full blown netdevice.  From Thomas Graf, Jiri Benc, and a cast of
      others.

  10) Add Identifier Locator Addressing support for ipv6, from Tom
      Herbert.

  11) Support fragmented SKBs in iwlwifi, from Johannes Berg.

  12) Allow perf PMUs to be accessed from eBPF programs, from Kaixu Xia.

  13) Add BQL support to 3c59x driver, from Loganaden Velvindron.

  14) Stop using a zero TX queue length to mean that a device shouldn't
      have a qdisc attached, use an explicit flag instead.  From Phil
      Sutter.

  15) Use generic geneve netdevice infrastructure in openvswitch, from
      Pravin B Shelar.

  16) Add infrastructure to avoid re-forwarding a packet in software
      that was already forwarded by a hardware switch.  From Scott
      Feldman.

  17) Allow AF_PACKET fanout function to be implemented in a bpf
      program, from Willem de Bruijn"

* git://git.kernel.org/pub/scm/linux/kernel/git/davem/net-next: (1458 commits)
  netfilter: nf_conntrack: make nf_ct_zone_dflt built-in
  netfilter: nf_dup{4, 6}: fix build error when nf_conntrack disabled
  net: fec: clear receive interrupts before processing a packet
  ipv6: fix exthdrs offload registration in out_rt path
  xen-netback: add support for multicast control
  bgmac: Update fixed_phy_register()
  sock, diag: fix panic in sock_diag_put_filterinfo
  flow_dissector: Use 'const' where possible.
  flow_dissector: Fix function argument ordering dependency
  ixgbe: Resolve "initialized field overwritten" warnings
  ixgbe: Remove bimodal SR-IOV disabling
  ixgbe: Add support for reporting 2.5G link speed
  ixgbe: fix bounds checking in ixgbe_setup_tc for 82598
  ixgbe: support for ethtool set_rxfh
  ixgbe: Avoid needless PHY access on copper phys
  ixgbe: cleanup to use cached mask value
  ixgbe: Remove second instance of lan_id variable
  ixgbe: use kzalloc for allocating one thing
  flow: Move __get_hash_from_flowi{4,6} into flow_dissector.c
  ixgbe: Remove unused PCI bus types
  ...

1 files changed, 28 insertions, 24 deletions

diff --git a/Documentation/networking/vxlan.txt b/Documentation/networking/vxlan.txt
index 6d993510f091..c28f4989c3f0 100644
--- a/Documentation/networking/vxlan.txt
+++ b/Documentation/networking/vxlan.txt
@@ -1,32 +1,36 @@
 Virtual eXtensible Local Area Networking documentation
 ======================================================
 
-The VXLAN protocol is a tunnelling protocol that is designed to
-solve the problem of limited number of available VLAN's (4096).
-With VXLAN identifier is expanded to 24 bits.
-
-It is a draft RFC standard, that is implemented by Cisco Nexus,
-Vmware and Brocade. The protocol runs over UDP using a single
-destination port (still not standardized by IANA).
-This document describes the Linux kernel tunnel device,
-there is also an implantation of VXLAN for Openvswitch.
-
-Unlike most tunnels, a VXLAN is a 1 to N network, not just point
-to point. A VXLAN device can either dynamically learn the IP address
-of the other end, in a manner similar to a learning bridge, or the
-forwarding entries can be configured statically.
-
-The management of vxlan is done in a similar fashion to it's
-too closest neighbors GRE and VLAN. Configuring VXLAN requires
-the version of iproute2 that matches the kernel release
-where VXLAN was first merged upstream.
+The VXLAN protocol is a tunnelling protocol designed to solve the
+problem of limited VLAN IDs (4096) in IEEE 802.1q.  With VXLAN the
+size of the identifier is expanded to 24 bits (16777216).
+
+VXLAN is described by IETF RFC 7348, and has been implemented by a
+number of vendors.  The protocol runs over UDP using a single
+destination port.  This document describes the Linux kernel tunnel
+device, there is also a separate implementation of VXLAN for
+Openvswitch.
+
+Unlike most tunnels, a VXLAN is a 1 to N network, not just point to
+point. A VXLAN device can learn the IP address of the other endpoint
+either dynamically in a manner similar to a learning bridge, or make
+use of statically-configured forwarding entries.
+
+The management of vxlan is done in a manner similar to its two closest
+neighbors GRE and VLAN. Configuring VXLAN requires the version of
+iproute2 that matches the kernel release where VXLAN was first merged
+upstream.
 
 1. Create vxlan device
-  # ip li add vxlan0 type vxlan id 42 group 239.1.1.1 dev eth1
-
-This creates a new device (vxlan0). The device uses the
-the multicast group 239.1.1.1 over eth1 to handle packets where
-no entry is in the forwarding table.
+ # ip link add vxlan0 type vxlan id 42 group 239.1.1.1 dev eth1 dstport 4789
+
+This creates a new device named vxlan0.  The device uses the multicast
+group 239.1.1.1 over eth1 to handle traffic for which there is no
+entry in the forwarding table.  The destination port number is set to
+the IANA-assigned value of 4789.  The Linux implementation of VXLAN
+pre-dates the IANA's selection of a standard destination port number
+and uses the Linux-selected value by default to maintain backwards
+compatibility.
 
 2. Delete vxlan device
   # ip link delete vxlan0