// SPDX-License-Identifier: GPL-2.0-only // // Copyright(c) 2020 Intel Corporation. All rights reserved. #include #include #include #include #include #include #include #include #include #include "../../codecs/rt1011.h" #include "sof_realtek_common.h" /* * Current only 2-amp configuration is supported for rt1011 */ static const struct snd_soc_dapm_route rt1011_dapm_routes[] = { /* speaker */ { "Left Spk", NULL, "Left SPO" }, { "Right Spk", NULL, "Right SPO" }, }; /* * Make sure device's Unique ID follows this configuration: * * Two speakers: * 0: left, 1: right * Four speakers: * 0: Woofer left, 1: Woofer right * 2: Tweeter left, 3: Tweeter right */ static struct snd_soc_codec_conf rt1011_codec_confs[] = { { .dlc = COMP_CODEC_CONF(RT1011_DEV0_NAME), .name_prefix = "Left", }, { .dlc = COMP_CODEC_CONF(RT1011_DEV1_NAME), .name_prefix = "Right", }, }; static struct snd_soc_dai_link_component rt1011_dai_link_components[] = { { .name = RT1011_DEV0_NAME, .dai_name = RT1011_CODEC_DAI, }, { .name = RT1011_DEV1_NAME, .dai_name = RT1011_CODEC_DAI, }, }; static const struct { unsigned int tx; unsigned int rx; } rt1011_tdm_mask[] = { {.tx = 0x4, .rx = 0x1}, {.tx = 0x8, .rx = 0x2}, }; static int rt1011_hw_params(struct snd_pcm_substream *substream, struct snd_pcm_hw_params *params) { struct snd_soc_pcm_runtime *rtd = asoc_substream_to_rtd(substream); struct snd_soc_dai *codec_dai; int srate, i, ret = 0; srate = params_rate(params); for_each_rtd_codec_dais(rtd, i, codec_dai) { /* 100 Fs to drive 24 bit data */ ret = snd_soc_dai_set_pll(codec_dai, 0, RT1011_PLL1_S_BCLK, 100 * srate, 256 * srate); if (ret < 0) { dev_err(codec_dai->dev, "fail to set pll, ret %d\n", ret); return ret; } ret = snd_soc_dai_set_sysclk(codec_dai, RT1011_FS_SYS_PRE_S_PLL1, 256 * srate, SND_SOC_CLOCK_IN); if (ret < 0) { dev_err(codec_dai->dev, "fail to set sysclk, ret %d\n", ret); return ret; } if (i >= ARRAY_SIZE(rt1011_tdm_mask)) { dev_err(codec_dai->dev, "invalid codec index %d\n", i); return -ENODEV; } ret = snd_soc_dai_set_tdm_slot(codec_dai, rt1011_tdm_mask[i].tx, rt1011_tdm_mask[i].rx, 4, params_width(params)); if (ret < 0) { dev_err(codec_dai->dev, "fail to set tdm slot, ret %d\n", ret); return ret; } } return 0; } static const struct snd_soc_ops rt1011_ops = { .hw_params = rt1011_hw_params, }; static int rt1011_init(struct snd_soc_pcm_runtime *rtd) { struct snd_soc_card *card = rtd->card; int ret; ret = snd_soc_dapm_add_routes(&card->dapm, rt1011_dapm_routes, ARRAY_SIZE(rt1011_dapm_routes)); if (ret) dev_err(rtd->dev, "Speaker map addition failed: %d\n", ret); return ret; } void sof_rt1011_dai_link(struct snd_soc_dai_link *link) { link->codecs = rt1011_dai_link_components; link->num_codecs = ARRAY_SIZE(rt1011_dai_link_components); link->init = rt1011_init; link->ops = &rt1011_ops; } void sof_rt1011_codec_conf(struct snd_soc_card *card) { card->codec_conf = rt1011_codec_confs; card->num_configs = ARRAY_SIZE(rt1011_codec_confs); } /* * rt1015: i2c mode driver for ALC1015 and ALC1015Q * rt1015p: auto-mode driver for ALC1015, ALC1015Q, and ALC1015Q-VB * * For stereo output, there are always two amplifiers on the board. * However, the ACPI implements only one device instance (UID=0) if they * are sharing the same enable pin. The code will detect the number of * device instance and use corresponding DAPM structures for * initialization. */ static const struct snd_soc_dapm_route rt1015p_1dev_dapm_routes[] = { /* speaker */ { "Left Spk", NULL, "Speaker" }, { "Right Spk", NULL, "Speaker" }, }; static const struct snd_soc_dapm_route rt1015p_2dev_dapm_routes[] = { /* speaker */ { "Left Spk", NULL, "Left Speaker" }, { "Right Spk", NULL, "Right Speaker" }, }; static struct snd_soc_codec_conf rt1015p_codec_confs[] = { { .dlc = COMP_CODEC_CONF(RT1015P_DEV0_NAME), .name_prefix = "Left", }, { .dlc = COMP_CODEC_CONF(RT1015P_DEV1_NAME), .name_prefix = "Right", }, }; static struct snd_soc_dai_link_component rt1015p_dai_link_components[] = { { .name = RT1015P_DEV0_NAME, .dai_name = RT1015P_CODEC_DAI, }, { .name = RT1015P_DEV1_NAME, .dai_name = RT1015P_CODEC_DAI, }, }; static int rt1015p_get_num_codecs(void) { static int dev_num; if (dev_num) return dev_num; if (!acpi_dev_present("RTL1015", "1", -1)) dev_num = 1; else dev_num = 2; return dev_num; } static int rt1015p_hw_params(struct snd_pcm_substream *substream, struct snd_pcm_hw_params *params) { /* reserved for debugging purpose */ return 0; } static const struct snd_soc_ops rt1015p_ops = { .hw_params = rt1015p_hw_params, }; static int rt1015p_init(struct snd_soc_pcm_runtime *rtd) { struct snd_soc_card *card = rtd->card; int ret; if (rt1015p_get_num_codecs() == 1) ret = snd_soc_dapm_add_routes(&card->dapm, rt1015p_1dev_dapm_routes, ARRAY_SIZE(rt1015p_1dev_dapm_routes)); else ret = snd_soc_dapm_add_routes(&card->dapm, rt1015p_2dev_dapm_routes, ARRAY_SIZE(rt1015p_2dev_dapm_routes)); if (ret) dev_err(rtd->dev, "Speaker map addition failed: %d\n", ret); return ret; } void sof_rt1015p_dai_link(struct snd_soc_dai_link *link) { link->codecs = rt1015p_dai_link_components; link->num_codecs = rt1015p_get_num_codecs(); link->init = rt1015p_init; link->ops = &rt1015p_ops; } void sof_rt1015p_codec_conf(struct snd_soc_card *card) { if (rt1015p_get_num_codecs() == 1) return; card->codec_conf = rt1015p_codec_confs; card->num_configs = ARRAY_SIZE(rt1015p_codec_confs); }