From 9c63634221f67450ead19820e33996b69691194f Mon Sep 17 00:00:00 2001 From: Dmitry Baryshkov Date: Wed, 10 Sep 2008 05:01:17 +0400 Subject: ALSA: Separate common pxa2xx-ac97 code ASoC and non-ASoC drivers for ACLINK on PXA share lot's of common code. Move all common code into separate module snd-pxa2xx-lib. [Fixed handing of SND_AC97_CODEC in Kconfig and some checkpatch warnings -- broonie] Signed-off-by: Dmitry Baryshkov Signed-off-by: Mark Brown Signed-off-by: Jaroslav Kysela --- sound/arm/pxa2xx-ac97.c | 247 ++++-------------------------------------------- 1 file changed, 18 insertions(+), 229 deletions(-) (limited to 'sound/arm/pxa2xx-ac97.c') diff --git a/sound/arm/pxa2xx-ac97.c b/sound/arm/pxa2xx-ac97.c index 199cca3366df..cba71d867542 100644 --- a/sound/arm/pxa2xx-ac97.c +++ b/sound/arm/pxa2xx-ac97.c @@ -12,198 +12,27 @@ #include #include -#include #include -#include -#include -#include -#include #include #include #include #include +#include -#include -#include #include #include -#include #include #include "pxa2xx-pcm.h" - -static DEFINE_MUTEX(car_mutex); -static DECLARE_WAIT_QUEUE_HEAD(gsr_wq); -static volatile long gsr_bits; -static struct clk *ac97_clk; -#ifdef CONFIG_PXA27x -static struct clk *ac97conf_clk; -#endif - -/* - * Beware PXA27x bugs: - * - * o Slot 12 read from modem space will hang controller. - * o CDONE, SDONE interrupt fails after any slot 12 IO. - * - * We therefore have an hybrid approach for waiting on SDONE (interrupt or - * 1 jiffy timeout if interrupt never comes). - */ - -static unsigned short pxa2xx_ac97_read(struct snd_ac97 *ac97, unsigned short reg) -{ - unsigned short val = -1; - volatile u32 *reg_addr; - - mutex_lock(&car_mutex); - - /* set up primary or secondary codec space */ - reg_addr = (ac97->num & 1) ? &SAC_REG_BASE : &PAC_REG_BASE; - reg_addr += (reg >> 1); - - /* start read access across the ac97 link */ - GSR = GSR_CDONE | GSR_SDONE; - gsr_bits = 0; - val = *reg_addr; - if (reg == AC97_GPIO_STATUS) - goto out; - if (wait_event_timeout(gsr_wq, (GSR | gsr_bits) & GSR_SDONE, 1) <= 0 && - !((GSR | gsr_bits) & GSR_SDONE)) { - printk(KERN_ERR "%s: read error (ac97_reg=%d GSR=%#lx)\n", - __func__, reg, GSR | gsr_bits); - val = -1; - goto out; - } - - /* valid data now */ - GSR = GSR_CDONE | GSR_SDONE; - gsr_bits = 0; - val = *reg_addr; - /* but we've just started another cycle... */ - wait_event_timeout(gsr_wq, (GSR | gsr_bits) & GSR_SDONE, 1); - -out: mutex_unlock(&car_mutex); - return val; -} - -static void pxa2xx_ac97_write(struct snd_ac97 *ac97, unsigned short reg, unsigned short val) -{ - volatile u32 *reg_addr; - - mutex_lock(&car_mutex); - - /* set up primary or secondary codec space */ - reg_addr = (ac97->num & 1) ? &SAC_REG_BASE : &PAC_REG_BASE; - reg_addr += (reg >> 1); - - GSR = GSR_CDONE | GSR_SDONE; - gsr_bits = 0; - *reg_addr = val; - if (wait_event_timeout(gsr_wq, (GSR | gsr_bits) & GSR_CDONE, 1) <= 0 && - !((GSR | gsr_bits) & GSR_CDONE)) - printk(KERN_ERR "%s: write error (ac97_reg=%d GSR=%#lx)\n", - __func__, reg, GSR | gsr_bits); - - mutex_unlock(&car_mutex); -} - static void pxa2xx_ac97_reset(struct snd_ac97 *ac97) { - /* First, try cold reset */ -#ifdef CONFIG_PXA3xx - int timeout; - - /* Hold CLKBPB for 100us */ - GCR = 0; - GCR = GCR_CLKBPB; - udelay(100); - GCR = 0; -#endif - - GCR &= GCR_COLD_RST; /* clear everything but nCRST */ - GCR &= ~GCR_COLD_RST; /* then assert nCRST */ - - gsr_bits = 0; -#ifdef CONFIG_PXA27x - /* PXA27x Developers Manual section 13.5.2.2.1 */ - clk_enable(ac97conf_clk); - udelay(5); - clk_disable(ac97conf_clk); - GCR = GCR_COLD_RST; - udelay(50); -#elif defined(CONFIG_PXA3xx) - timeout = 1000; - /* Can't use interrupts on PXA3xx */ - GCR &= ~(GCR_PRIRDY_IEN|GCR_SECRDY_IEN); - - GCR = GCR_WARM_RST | GCR_COLD_RST; - while (!(GSR & (GSR_PCR | GSR_SCR)) && timeout--) - mdelay(10); -#else - GCR = GCR_COLD_RST; - GCR |= GCR_CDONE_IE|GCR_SDONE_IE; - wait_event_timeout(gsr_wq, gsr_bits & (GSR_PCR | GSR_SCR), 1); -#endif - - if (!((GSR | gsr_bits) & (GSR_PCR | GSR_SCR))) { - printk(KERN_INFO "%s: cold reset timeout (GSR=%#lx)\n", - __func__, gsr_bits); - - /* let's try warm reset */ - gsr_bits = 0; -#ifdef CONFIG_PXA27x - /* warm reset broken on Bulverde, - so manually keep AC97 reset high */ - pxa_gpio_mode(113 | GPIO_OUT | GPIO_DFLT_HIGH); - udelay(10); - GCR |= GCR_WARM_RST; - pxa_gpio_mode(113 | GPIO_ALT_FN_2_OUT); - udelay(500); -#elif defined(CONFIG_PXA3xx) - timeout = 100; - /* Can't use interrupts */ - GCR |= GCR_WARM_RST; - while (!((GSR | gsr_bits) & (GSR_PCR | GSR_SCR)) && timeout--) - mdelay(1); -#else - GCR |= GCR_WARM_RST|GCR_PRIRDY_IEN|GCR_SECRDY_IEN; - wait_event_timeout(gsr_wq, gsr_bits & (GSR_PCR | GSR_SCR), 1); -#endif - - if (!((GSR | gsr_bits) & (GSR_PCR | GSR_SCR))) - printk(KERN_INFO "%s: warm reset timeout (GSR=%#lx)\n", - __func__, gsr_bits); - } - - GCR &= ~(GCR_PRIRDY_IEN|GCR_SECRDY_IEN); - GCR |= GCR_SDONE_IE|GCR_CDONE_IE; -} - -static irqreturn_t pxa2xx_ac97_irq(int irq, void *dev_id) -{ - long status; - - status = GSR; - if (status) { - GSR = status; - gsr_bits |= status; - wake_up(&gsr_wq); - -#ifdef CONFIG_PXA27x - /* Although we don't use those we still need to clear them - since they tend to spuriously trigger when MMC is used - (hardware bug? go figure)... */ - MISR = MISR_EOC; - PISR = PISR_EOC; - MCSR = MCSR_EOC; -#endif - - return IRQ_HANDLED; + if (!pxa2xx_ac97_try_cold_reset(ac97)) { + pxa2xx_ac97_try_warm_reset(ac97); } - return IRQ_NONE; + pxa2xx_ac97_finish_reset(ac97); } static struct snd_ac97_bus_ops pxa2xx_ac97_ops = { @@ -288,17 +117,19 @@ static int pxa2xx_ac97_do_suspend(struct snd_card *card, pm_message_t state) snd_ac97_suspend(pxa2xx_ac97_ac97); if (platform_ops && platform_ops->suspend) platform_ops->suspend(platform_ops->priv); - GCR |= GCR_ACLINK_OFF; - clk_disable(ac97_clk); - return 0; + return pxa2xx_ac97_hw_suspend(); } static int pxa2xx_ac97_do_resume(struct snd_card *card) { pxa2xx_audio_ops_t *platform_ops = card->dev->platform_data; + int rc; + + rc = pxa2xx_ac97_hw_resume(); + if (rc) + return rc; - clk_enable(ac97_clk); if (platform_ops && platform_ops->resume) platform_ops->resume(platform_ops->priv); snd_ac97_resume(pxa2xx_ac97_ac97); @@ -354,40 +185,17 @@ static int __devinit pxa2xx_ac97_probe(struct platform_device *dev) if (ret) goto err; - ret = request_irq(IRQ_AC97, pxa2xx_ac97_irq, 0, "AC97", NULL); - if (ret < 0) - goto err; - - pxa_gpio_mode(GPIO31_SYNC_AC97_MD); - pxa_gpio_mode(GPIO30_SDATA_OUT_AC97_MD); - pxa_gpio_mode(GPIO28_BITCLK_AC97_MD); - pxa_gpio_mode(GPIO29_SDATA_IN_AC97_MD); -#ifdef CONFIG_PXA27x - /* Use GPIO 113 as AC97 Reset on Bulverde */ - pxa_gpio_mode(113 | GPIO_ALT_FN_2_OUT); - ac97conf_clk = clk_get(&dev->dev, "AC97CONFCLK"); - if (IS_ERR(ac97conf_clk)) { - ret = PTR_ERR(ac97conf_clk); - ac97conf_clk = NULL; - goto err; - } -#endif - - ac97_clk = clk_get(&dev->dev, "AC97CLK"); - if (IS_ERR(ac97_clk)) { - ret = PTR_ERR(ac97_clk); - ac97_clk = NULL; + ret = pxa2xx_ac97_hw_probe(dev); + if (ret) goto err; - } - clk_enable(ac97_clk); ret = snd_ac97_bus(card, 0, &pxa2xx_ac97_ops, NULL, &ac97_bus); if (ret) - goto err; + goto err_remove; memset(&ac97_template, 0, sizeof(ac97_template)); ret = snd_ac97_mixer(ac97_bus, &ac97_template, &pxa2xx_ac97_ac97); if (ret) - goto err; + goto err_remove; snprintf(card->shortname, sizeof(card->shortname), "%s", snd_ac97_get_short_name(pxa2xx_ac97_ac97)); @@ -401,22 +209,11 @@ static int __devinit pxa2xx_ac97_probe(struct platform_device *dev) return 0; } - err: +err_remove: + pxa2xx_ac97_hw_remove(dev); +err: if (card) snd_card_free(card); - if (ac97_clk) { - GCR |= GCR_ACLINK_OFF; - free_irq(IRQ_AC97, NULL); - clk_disable(ac97_clk); - clk_put(ac97_clk); - ac97_clk = NULL; - } -#ifdef CONFIG_PXA27x - if (ac97conf_clk) { - clk_put(ac97conf_clk); - ac97conf_clk = NULL; - } -#endif return ret; } @@ -427,15 +224,7 @@ static int __devexit pxa2xx_ac97_remove(struct platform_device *dev) if (card) { snd_card_free(card); platform_set_drvdata(dev, NULL); - GCR |= GCR_ACLINK_OFF; - free_irq(IRQ_AC97, NULL); - clk_disable(ac97_clk); - clk_put(ac97_clk); - ac97_clk = NULL; -#ifdef CONFIG_PXA27x - clk_put(ac97conf_clk); - ac97conf_clk = NULL; -#endif + pxa2xx_ac97_hw_remove(dev); } return 0; -- cgit v1.2.3