From 4737f0978d6e64eae468e01fa181abf6499e6b84 Mon Sep 17 00:00:00 2001 From: Pavel Machek Date: Fri, 5 Jun 2009 00:44:53 +0200 Subject: trivial: Kconfig: .ko is normally not included in module names .ko is normally not included in Kconfig help, make it consistent. Signed-off-by: Pavel Machek Signed-off-by: Jiri Kosina --- drivers/w1/Kconfig | 2 +- drivers/w1/masters/Kconfig | 6 +++--- 2 files changed, 4 insertions(+), 4 deletions(-) (limited to 'drivers/w1') diff --git a/drivers/w1/Kconfig b/drivers/w1/Kconfig index 9adbb4f90479..fd2c7bd9dfbe 100644 --- a/drivers/w1/Kconfig +++ b/drivers/w1/Kconfig @@ -8,7 +8,7 @@ menuconfig W1 If you want W1 support, you should say Y here. This W1 support can also be built as a module. If so, the module - will be called wire.ko. + will be called wire. if W1 diff --git a/drivers/w1/masters/Kconfig b/drivers/w1/masters/Kconfig index 96d2f8e4c275..3195fb8b7d9a 100644 --- a/drivers/w1/masters/Kconfig +++ b/drivers/w1/masters/Kconfig @@ -12,7 +12,7 @@ config W1_MASTER_MATROX using Matrox's G400 GPIO pins. This support is also available as a module. If so, the module - will be called matrox_w1.ko. + will be called matrox_w1. config W1_MASTER_DS2490 tristate "DS2490 USB <-> W1 transport layer for 1-wire" @@ -22,7 +22,7 @@ config W1_MASTER_DS2490 for example DS9490*. This support is also available as a module. If so, the module - will be called ds2490.ko. + will be called ds2490. config W1_MASTER_DS2482 tristate "Maxim DS2482 I2C to 1-Wire bridge" @@ -56,7 +56,7 @@ config W1_MASTER_GPIO GPIO pins. This driver uses the GPIO API to control the wire. This support is also available as a module. If so, the module - will be called w1-gpio.ko. + will be called w1-gpio. config HDQ_MASTER_OMAP tristate "OMAP HDQ driver" -- cgit v1.2.3