From 4e5c9e6fa2d232a0686d5fe45cd1508484048936 Mon Sep 17 00:00:00 2001 From: Roger Quadros Date: Fri, 14 Jun 2013 16:52:07 +0300 Subject: USB: ehci-omap: Tweak PHY initialization sequence For PHY mode, the PHYs must be brought out of reset before the EHCI controller is started. This patch fixes the issue where USB devices are not found on Beagleboard/Beagle-xm if USB has been started previously by the bootloader. (e.g. by "usb start" command in u-boot) Tested on Beagleboard, Beagleboard-xm and Pandaboard. Issue present on 3.10 onwards. Reported-by: Tomi Valkeinen Tested-by: Tomi Valkeinen Signed-off-by: Roger Quadros Cc: stable # 3.10 Signed-off-by: Greg Kroah-Hartman --- drivers/usb/host/ehci-omap.c | 11 +++++++++-- 1 file changed, 9 insertions(+), 2 deletions(-) (limited to 'drivers/usb') diff --git a/drivers/usb/host/ehci-omap.c b/drivers/usb/host/ehci-omap.c index bafa960ffd92..9bd7dfe3315b 100644 --- a/drivers/usb/host/ehci-omap.c +++ b/drivers/usb/host/ehci-omap.c @@ -187,6 +187,12 @@ static int ehci_hcd_omap_probe(struct platform_device *pdev) } omap->phy[i] = phy; + + if (pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY) { + usb_phy_init(omap->phy[i]); + /* bring PHY out of suspend */ + usb_phy_set_suspend(omap->phy[i], 0); + } } pm_runtime_enable(dev); @@ -211,13 +217,14 @@ static int ehci_hcd_omap_probe(struct platform_device *pdev) } /* - * Bring PHYs out of reset. + * Bring PHYs out of reset for non PHY modes. * Even though HSIC mode is a PHY-less mode, the reset * line exists between the chips and can be modelled * as a PHY device for reset control. */ for (i = 0; i < omap->nports; i++) { - if (!omap->phy[i]) + if (!omap->phy[i] || + pdata->port_mode[i] == OMAP_EHCI_PORT_MODE_PHY) continue; usb_phy_init(omap->phy[i]); -- cgit v1.2.3