From 2acecd58969897795cf015c9057ebd349a3fda8a Mon Sep 17 00:00:00 2001 From: Yoshihiro Shimoda Date: Wed, 2 Aug 2017 13:21:45 +0900 Subject: usb: renesas_usbhs: Fix UGCTRL2 value for R-Car Gen3 The latest HW manual (Rev.0.55) shows us this UGCTRL2.VBUSSEL bit. If the bit sets to 1, the VBUS drive is controlled by phy related registers (called "UCOM Registers" on the manual). Since R-Car Gen3 environment will control VBUS by phy-rcar-gen3-usb2 driver, the UGCTRL2.VBUSSEL bit should be set to 1. So, this patch fixes the register's value. Otherwise, even if the ID pin indicates to peripheral, the R-Car will output USBn_PWEN to 1 when a host driver is running. Fixes: de18757e272d ("usb: renesas_usbhs: add R-Car Gen3 power control" Cc: # v4.6+ Signed-off-by: Yoshihiro Shimoda Signed-off-by: Felipe Balbi --- drivers/usb/renesas_usbhs/rcar3.c | 9 +++++++-- 1 file changed, 7 insertions(+), 2 deletions(-) (limited to 'drivers/usb/renesas_usbhs') diff --git a/drivers/usb/renesas_usbhs/rcar3.c b/drivers/usb/renesas_usbhs/rcar3.c index d544b331c9f2..02b67abfc2a1 100644 --- a/drivers/usb/renesas_usbhs/rcar3.c +++ b/drivers/usb/renesas_usbhs/rcar3.c @@ -20,9 +20,13 @@ /* Low Power Status register (LPSTS) */ #define LPSTS_SUSPM 0x4000 -/* USB General control register 2 (UGCTRL2), bit[31:6] should be 0 */ +/* + * USB General control register 2 (UGCTRL2) + * Remarks: bit[31:11] and bit[9:6] should be 0 + */ #define UGCTRL2_RESERVED_3 0x00000001 /* bit[3:0] should be B'0001 */ #define UGCTRL2_USB0SEL_OTG 0x00000030 +#define UGCTRL2_VBUSSEL 0x00000400 static void usbhs_write32(struct usbhs_priv *priv, u32 reg, u32 data) { @@ -34,7 +38,8 @@ static int usbhs_rcar3_power_ctrl(struct platform_device *pdev, { struct usbhs_priv *priv = usbhs_pdev_to_priv(pdev); - usbhs_write32(priv, UGCTRL2, UGCTRL2_RESERVED_3 | UGCTRL2_USB0SEL_OTG); + usbhs_write32(priv, UGCTRL2, UGCTRL2_RESERVED_3 | UGCTRL2_USB0SEL_OTG | + UGCTRL2_VBUSSEL); if (enable) { usbhs_bset(priv, LPSTS, LPSTS_SUSPM, LPSTS_SUSPM); -- cgit v1.2.3