From 7c2861a6fb2c502d7b7aa85415e178f3c527a468 Mon Sep 17 00:00:00 2001 From: Alexey Khoroshilov Date: Sat, 17 Mar 2018 13:05:44 +0300 Subject: spi: jcore: disable ref_clk after getting its rate The driver does not disable ref_clk on remove. According to the comment, the only reason to enable the clock is to get its rate. So, it should be safe to disable clk just after that. By the way, clk_prepare_enable() looks to be more appropriate than clk_enable() here. Found by Linux Driver Verification project (linuxtesting.org). Signed-off-by: Alexey Khoroshilov Signed-off-by: Mark Brown --- drivers/spi/spi-jcore.c | 11 +++++------ 1 file changed, 5 insertions(+), 6 deletions(-) (limited to 'drivers/spi') diff --git a/drivers/spi/spi-jcore.c b/drivers/spi/spi-jcore.c index dafed6280df3..702fe573a47b 100644 --- a/drivers/spi/spi-jcore.c +++ b/drivers/spi/spi-jcore.c @@ -184,10 +184,11 @@ static int jcore_spi_probe(struct platform_device *pdev) */ clock_freq = 50000000; clk = devm_clk_get(&pdev->dev, "ref_clk"); - if (!IS_ERR_OR_NULL(clk)) { - if (clk_enable(clk) == 0) + if (!IS_ERR(clk)) { + if (clk_prepare_enable(clk) == 0) { clock_freq = clk_get_rate(clk); - else + clk_disable_unprepare(clk); + } else dev_warn(&pdev->dev, "could not enable ref_clk\n"); } hw->clock_freq = clock_freq; @@ -198,10 +199,8 @@ static int jcore_spi_probe(struct platform_device *pdev) /* Register our spi controller */ err = devm_spi_register_master(&pdev->dev, master); - if (err) { - clk_disable(clk); + if (err) goto exit; - } return 0; -- cgit v1.2.3