From dd11444327ce0fd549cce552b04aa441688ef2d3 Mon Sep 17 00:00:00 2001 From: Thor Thayer Date: Thu, 12 Mar 2015 14:19:31 -0500 Subject: spi: dw-spi: Convert 16bit accesses to 32bit accesses Altera's Arria10 SoC interconnect requires a 32-bit write for APB peripherals. The current spi-dw driver uses 16-bit accesses in some locations. This patch converts all the 16-bit reads and writes to 32-bit reads and writes. Additional Documentation to Support this Change: The DW_apb_ssi databook states: "All registers in the DW_apb_ssi are addressed at 32-bit boundaries to remain consistent with the AHB bus. Where the physical size of any register is less than 32-bits wide, the upper unused bits of the 32-bit boundary are reserved. Writing to these bits has no effect; reading from these bits returns 0." [1] [1] Section 6.1 of dw_apb_ssi.pdf (version 3.22a) Request for test with platforms using the DesignWare SPI IP. Tested On: Altera CycloneV development kit Altera Arria10 development kit Compile tested for build errors on x86_64 (allyesconfigs) Signed-off-by: Thor Thayer Reviewed-and-tested-by: Andy Shevchenko Signed-off-by: Mark Brown --- drivers/spi/spi-dw.c | 24 ++++++++++++------------ 1 file changed, 12 insertions(+), 12 deletions(-) (limited to 'drivers/spi/spi-dw.c') diff --git a/drivers/spi/spi-dw.c b/drivers/spi/spi-dw.c index 0f0106933b52..cafac221fbf6 100644 --- a/drivers/spi/spi-dw.c +++ b/drivers/spi/spi-dw.c @@ -157,7 +157,7 @@ static inline u32 tx_max(struct dw_spi *dws) u32 tx_left, tx_room, rxtx_gap; tx_left = (dws->tx_end - dws->tx) / dws->n_bytes; - tx_room = dws->fifo_len - dw_readw(dws, DW_SPI_TXFLR); + tx_room = dws->fifo_len - dw_readl(dws, DW_SPI_TXFLR); /* * Another concern is about the tx/rx mismatch, we @@ -178,7 +178,7 @@ static inline u32 rx_max(struct dw_spi *dws) { u32 rx_left = (dws->rx_end - dws->rx) / dws->n_bytes; - return min_t(u32, rx_left, dw_readw(dws, DW_SPI_RXFLR)); + return min_t(u32, rx_left, dw_readl(dws, DW_SPI_RXFLR)); } static void dw_writer(struct dw_spi *dws) @@ -194,7 +194,7 @@ static void dw_writer(struct dw_spi *dws) else txw = *(u16 *)(dws->tx); } - dw_writew(dws, DW_SPI_DR, txw); + dw_writel(dws, DW_SPI_DR, txw); dws->tx += dws->n_bytes; } } @@ -205,7 +205,7 @@ static void dw_reader(struct dw_spi *dws) u16 rxw; while (max--) { - rxw = dw_readw(dws, DW_SPI_DR); + rxw = dw_readl(dws, DW_SPI_DR); /* Care rx only if the transfer's original "rx" is not null */ if (dws->rx_end - dws->len) { if (dws->n_bytes == 1) @@ -228,11 +228,11 @@ static void int_error_stop(struct dw_spi *dws, const char *msg) static irqreturn_t interrupt_transfer(struct dw_spi *dws) { - u16 irq_status = dw_readw(dws, DW_SPI_ISR); + u16 irq_status = dw_readl(dws, DW_SPI_ISR); /* Error handling */ if (irq_status & (SPI_INT_TXOI | SPI_INT_RXOI | SPI_INT_RXUI)) { - dw_readw(dws, DW_SPI_ICR); + dw_readl(dws, DW_SPI_ICR); int_error_stop(dws, "interrupt_transfer: fifo overrun/underrun"); return IRQ_HANDLED; } @@ -257,7 +257,7 @@ static irqreturn_t dw_spi_irq(int irq, void *dev_id) { struct spi_master *master = dev_id; struct dw_spi *dws = spi_master_get_devdata(master); - u16 irq_status = dw_readw(dws, DW_SPI_ISR) & 0x3f; + u16 irq_status = dw_readl(dws, DW_SPI_ISR) & 0x3f; if (!irq_status) return IRQ_NONE; @@ -354,7 +354,7 @@ static int dw_spi_transfer_one(struct spi_master *master, cr0 |= (chip->tmode << SPI_TMOD_OFFSET); } - dw_writew(dws, DW_SPI_CTRL0, cr0); + dw_writel(dws, DW_SPI_CTRL0, cr0); /* Check if current transfer is a DMA transaction */ if (master->can_dma && master->can_dma(master, spi, transfer)) @@ -375,7 +375,7 @@ static int dw_spi_transfer_one(struct spi_master *master, } } else if (!chip->poll_mode) { txlevel = min_t(u16, dws->fifo_len / 2, dws->len / dws->n_bytes); - dw_writew(dws, DW_SPI_TXFLTR, txlevel); + dw_writel(dws, DW_SPI_TXFLTR, txlevel); /* Set the interrupt mask */ imask |= SPI_INT_TXEI | SPI_INT_TXOI | @@ -499,11 +499,11 @@ static void spi_hw_init(struct device *dev, struct dw_spi *dws) u32 fifo; for (fifo = 1; fifo < 256; fifo++) { - dw_writew(dws, DW_SPI_TXFLTR, fifo); - if (fifo != dw_readw(dws, DW_SPI_TXFLTR)) + dw_writel(dws, DW_SPI_TXFLTR, fifo); + if (fifo != dw_readl(dws, DW_SPI_TXFLTR)) break; } - dw_writew(dws, DW_SPI_TXFLTR, 0); + dw_writel(dws, DW_SPI_TXFLTR, 0); dws->fifo_len = (fifo == 1) ? 0 : fifo; dev_dbg(dev, "Detected FIFO size: %u bytes\n", dws->fifo_len); -- cgit v1.2.3