From 16da0eb5ab6ef2dd1d33431199126e63db9997cc Mon Sep 17 00:00:00 2001 From: Krzysztof Kozlowski Date: Sat, 29 Jun 2019 13:44:45 +0200 Subject: regulator: s2mps11: Fix buck7 and buck8 wrong voltages On S2MPS11 device, the buck7 and buck8 regulator voltages start at 750 mV, not 600 mV. Using wrong minimal value caused shifting of these regulator values by 150 mV (e.g. buck7 usually configured to v1.35 V was reported as 1.2 V). On most of the boards these regulators are left in default state so this was only affecting reported voltage. However if any driver wanted to change them, then effectively it would set voltage 150 mV higher than intended. Cc: Fixes: cb74685ecb39 ("regulator: s2mps11: Add samsung s2mps11 regulator driver") Signed-off-by: Krzysztof Kozlowski Signed-off-by: Mark Brown --- drivers/regulator/s2mps11.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) (limited to 'drivers/regulator') diff --git a/drivers/regulator/s2mps11.c b/drivers/regulator/s2mps11.c index af9bf10b4c33..7a89030187a4 100644 --- a/drivers/regulator/s2mps11.c +++ b/drivers/regulator/s2mps11.c @@ -372,8 +372,8 @@ static const struct regulator_desc s2mps11_regulators[] = { regulator_desc_s2mps11_buck1_4(4), regulator_desc_s2mps11_buck5, regulator_desc_s2mps11_buck67810(6, MIN_600_MV, STEP_6_25_MV), - regulator_desc_s2mps11_buck67810(7, MIN_600_MV, STEP_12_5_MV), - regulator_desc_s2mps11_buck67810(8, MIN_600_MV, STEP_12_5_MV), + regulator_desc_s2mps11_buck67810(7, MIN_750_MV, STEP_12_5_MV), + regulator_desc_s2mps11_buck67810(8, MIN_750_MV, STEP_12_5_MV), regulator_desc_s2mps11_buck9, regulator_desc_s2mps11_buck67810(10, MIN_750_MV, STEP_12_5_MV), }; -- cgit v1.2.3