From 885bd765963b42c380db442db7f1c0f2a26076fa Mon Sep 17 00:00:00 2001 From: Bjorn Andersson Date: Tue, 4 Jun 2019 16:24:43 -0700 Subject: phy: qcom-qmp: Correct READY_STATUS poll break condition After issuing a PHY_START request to the QMP, the hardware documentation states that the software should wait for the PCS_READY_STATUS to become 1. With the introduction of commit c9b589791fc1 ("phy: qcom: Utilize UFS reset controller") an additional 1ms delay was introduced between the start request and the check of the status bit. This greatly increases the chances for the hardware to actually becoming ready before the status bit is read. The result can be seen in that UFS PHY enabling is now reported as a failure in 10% of the boots on SDM845, which is a clear regression from the previous rare/occasional failure. This patch fixes the "break condition" of the poll to check for the correct state of the status bit. Unfortunately PCIe on 8996 and 8998 does not specify the mask_pcs_ready register, which means that the code checks a bit that's always 0. So the patch also fixes these, in order to not regress these targets. Fixes: 73d7ec899bd8 ("phy: qcom-qmp: Add msm8998 PCIe QMP PHY support") Fixes: e78f3d15e115 ("phy: qcom-qmp: new qmp phy driver for qcom-chipsets") Cc: stable@vger.kernel.org Cc: Evan Green Cc: Marc Gonzalez Cc: Vivek Gautam Reviewed-by: Evan Green Reviewed-by: Niklas Cassel Reviewed-by: Marc Gonzalez Tested-by: Marc Gonzalez Signed-off-by: Bjorn Andersson Signed-off-by: Kishon Vijay Abraham I --- drivers/phy/qualcomm/phy-qcom-qmp.c | 4 +++- 1 file changed, 3 insertions(+), 1 deletion(-) (limited to 'drivers/phy') diff --git a/drivers/phy/qualcomm/phy-qcom-qmp.c b/drivers/phy/qualcomm/phy-qcom-qmp.c index cd91b4179b10..43abdfd0deed 100644 --- a/drivers/phy/qualcomm/phy-qcom-qmp.c +++ b/drivers/phy/qualcomm/phy-qcom-qmp.c @@ -1074,6 +1074,7 @@ static const struct qmp_phy_cfg msm8996_pciephy_cfg = { .start_ctrl = PCS_START | PLL_READY_GATE_EN, .pwrdn_ctrl = SW_PWRDN | REFCLK_DRV_DSBL, + .mask_pcs_ready = PHYSTATUS, .mask_com_pcs_ready = PCS_READY, .has_phy_com_ctrl = true, @@ -1253,6 +1254,7 @@ static const struct qmp_phy_cfg msm8998_pciephy_cfg = { .start_ctrl = SERDES_START | PCS_START, .pwrdn_ctrl = SW_PWRDN | REFCLK_DRV_DSBL, + .mask_pcs_ready = PHYSTATUS, .mask_com_pcs_ready = PCS_READY, }; @@ -1547,7 +1549,7 @@ static int qcom_qmp_phy_enable(struct phy *phy) status = pcs + cfg->regs[QPHY_PCS_READY_STATUS]; mask = cfg->mask_pcs_ready; - ret = readl_poll_timeout(status, val, !(val & mask), 1, + ret = readl_poll_timeout(status, val, val & mask, 1, PHY_INIT_COMPLETE_TIMEOUT); if (ret) { dev_err(qmp->dev, "phy initialization timed-out\n"); -- cgit v1.2.3