From 6649b205ab1234c7b0ffbfba769f0604810c8ce2 Mon Sep 17 00:00:00 2001 From: Nikita Kiryanov Date: Wed, 16 Oct 2013 11:41:31 +0300 Subject: dm9000: during init reset phy only for dm9000b Some of the changes introduced in commit 6741f40 (DM9000B: driver initialization upgrade) break functionality on DM9000A (error message during NFS boot: "dm9000 dm9000.0: eth0: link down") Since the changes were meant to serve only DM9000B, make them dependent on the chip type. Cc: David S. Miller Cc: Jingoo Han Cc: Mugunthan V N Signed-off-by: Nikita Kiryanov Signed-off-by: Igor Grinberg Signed-off-by: David S. Miller --- drivers/net/ethernet/davicom/dm9000.c | 9 +++++++-- 1 file changed, 7 insertions(+), 2 deletions(-) (limited to 'drivers/net') diff --git a/drivers/net/ethernet/davicom/dm9000.c b/drivers/net/ethernet/davicom/dm9000.c index 5f5896e522d2..912983b39492 100644 --- a/drivers/net/ethernet/davicom/dm9000.c +++ b/drivers/net/ethernet/davicom/dm9000.c @@ -891,8 +891,13 @@ dm9000_init_dm9000(struct net_device *dev) iow(db, DM9000_GPCR, GPCR_GEP_CNTL); /* Let GPIO0 output */ - dm9000_phy_write(dev, 0, MII_BMCR, BMCR_RESET); /* PHY RESET */ - dm9000_phy_write(dev, 0, MII_DM_DSPCR, DSPCR_INIT_PARAM); /* Init */ + /* If we are dealing with DM9000B, some extra steps are required: a + * manual phy reset, and setting init params. + */ + if (db->type == TYPE_DM9000B) { + dm9000_phy_write(dev, 0, MII_BMCR, BMCR_RESET); + dm9000_phy_write(dev, 0, MII_DM_DSPCR, DSPCR_INIT_PARAM); + } ncr = (db->flags & DM9000_PLATF_EXT_PHY) ? NCR_EXT_PHY : 0; -- cgit v1.2.3