From 714afd35065b6b5ad5a384d7401a82a3db50a477 Mon Sep 17 00:00:00 2001 From: Shahar S Matityahu Date: Wed, 23 Jan 2019 11:31:58 +0200 Subject: iwlwifi: remove redundant condition from prior alive dump flow After the FW image was loaded for the first time, fwrt->smem_cfg.num_lmacs value will no longer be zero since we don't clean it when we stop the device. So if we load the image once and then we fail on a consecutive attempt, the driver will abort any dumping. Solve this by removing the condition. It is safe to remove since when we do the actual dumping in iwl_fw_dbg_collect_sync we check that STATUS_DEVICE_ENABLED bit is still active. Signed-off-by: Shahar S Matityahu Signed-off-by: Luca Coelho --- drivers/net/wireless/intel/iwlwifi/fw/dbg.c | 16 ---------------- 1 file changed, 16 deletions(-) (limited to 'drivers/net/wireless/intel') diff --git a/drivers/net/wireless/intel/iwlwifi/fw/dbg.c b/drivers/net/wireless/intel/iwlwifi/fw/dbg.c index 202f96e9ca0c..b189a605ec13 100644 --- a/drivers/net/wireless/intel/iwlwifi/fw/dbg.c +++ b/drivers/net/wireless/intel/iwlwifi/fw/dbg.c @@ -1592,22 +1592,6 @@ int iwl_fw_dbg_collect_desc(struct iwl_fw_runtime *fwrt, bool monitor_only, unsigned int delay) { - /* - * If the loading of the FW completed successfully, the next step is to - * get the SMEM config data. Thus, if fwrt->smem_cfg.num_lmacs is non - * zero, the FW was already loaded successully. If the state is "NO_FW" - * in such a case - exit, since FW may be dead. Otherwise, we - * can try to collect the data, since FW might just not be fully - * loaded (no "ALIVE" yet), and the debug data is accessible. - * - * Corner case: got the FW alive but crashed before getting the SMEM - * config. In such a case, due to HW access problems, we might - * collect garbage. - */ - if (fwrt->trans->state == IWL_TRANS_NO_FW && - fwrt->smem_cfg.num_lmacs) - return -EIO; - if (test_and_set_bit(IWL_FWRT_STATUS_DUMPING, &fwrt->status)) return -EBUSY; -- cgit v1.2.3