From 489815ce224e75c2fcd5ebdfaa740d7f9a4f20d3 Mon Sep 17 00:00:00 2001 From: Auke Kok Date: Thu, 21 Feb 2008 15:11:07 -0800 Subject: e1000e: fix spelling errors in comments Fix some spelling errors and inconsistencies in comment blocks. Signed-off-by: Auke Kok Signed-off-by: Jeff Garzik --- drivers/net/e1000e/phy.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) (limited to 'drivers/net/e1000e/phy.c') diff --git a/drivers/net/e1000e/phy.c b/drivers/net/e1000e/phy.c index fc6fee112f1c..dab3c468a768 100644 --- a/drivers/net/e1000e/phy.c +++ b/drivers/net/e1000e/phy.c @@ -121,7 +121,7 @@ s32 e1000e_phy_reset_dsp(struct e1000_hw *hw) * @offset: register offset to be read * @data: pointer to the read data * - * Reads the MDI control regsiter in the PHY at offset and stores the + * Reads the MDI control register in the PHY at offset and stores the * information read to data. **/ static s32 e1000_read_phy_reg_mdic(struct e1000_hw *hw, u32 offset, u16 *data) @@ -1172,7 +1172,7 @@ s32 e1000e_set_d3_lplu_state(struct e1000_hw *hw, bool active) } /** - * e1000e_check_downshift - Checks whether a downshift in speed occured + * e1000e_check_downshift - Checks whether a downshift in speed occurred * @hw: pointer to the HW structure * * Success returns 0, Failure returns 1 @@ -1388,8 +1388,8 @@ s32 e1000e_get_cable_length_m88(struct e1000_hw *hw) * * The automatic gain control (agc) normalizes the amplitude of the * received signal, adjusting for the attenuation produced by the - * cable. By reading the AGC registers, which reperesent the - * cobination of course and fine gain value, the value can be put + * cable. By reading the AGC registers, which represent the + * combination of course and fine gain value, the value can be put * into a lookup table to obtain the approximate cable length * for each channel. **/ @@ -1619,7 +1619,7 @@ s32 e1000e_phy_sw_reset(struct e1000_hw *hw) * Verify the reset block is not blocking us from resetting. Acquire * semaphore (if necessary) and read/set/write the device control reset * bit in the PHY. Wait the appropriate delay time for the device to - * reset and relase the semaphore (if necessary). + * reset and release the semaphore (if necessary). **/ s32 e1000e_phy_hw_reset_generic(struct e1000_hw *hw) { -- cgit v1.2.3