From 3f9738f73ad08ef770df64f145007bd27ac2fa16 Mon Sep 17 00:00:00 2001 From: Jianjun kong Date: Mon, 20 Apr 2009 23:48:25 +0000 Subject: 8139too: fix HW initial flow While ifconfig eth0 up kernel calls open() of 8139 driver(8139too.c). In rtl8139_hw_start() of rtl8139_open(), 8139 driver enable RX before setting up the DMA buffer address. In this interval where RX was enabled and DMA buffer address is not yet set up, any incoming broadcast packet would be send to a strange physical address: 0x003e8800 which is the default value of DMA buffer address. Unfortunately, this address is used by Linux kernel. So kernel panics. This patch fix it by setting up DMA buffer address before RX enabled and everything is fine even under broadcast packets attack. Signed-off-by: Jonathan Lin Signed-off-by: Amos Kong Signed-off-by: Eric Dumazet Signed-off-by: David S. Miller --- drivers/net/8139too.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) (limited to 'drivers/net/8139too.c') diff --git a/drivers/net/8139too.c b/drivers/net/8139too.c index 29df398b7727..1fc45431a620 100644 --- a/drivers/net/8139too.c +++ b/drivers/net/8139too.c @@ -1383,6 +1383,11 @@ static void rtl8139_hw_start (struct net_device *dev) RTL_W32_F (MAC0 + 0, le32_to_cpu (*(__le32 *) (dev->dev_addr + 0))); RTL_W32_F (MAC0 + 4, le16_to_cpu (*(__le16 *) (dev->dev_addr + 4))); + tp->cur_rx = 0; + + /* init Rx ring buffer DMA address */ + RTL_W32_F (RxBuf, tp->rx_ring_dma); + /* Must enable Tx/Rx before setting transfer thresholds! */ RTL_W8 (ChipCmd, CmdRxEnb | CmdTxEnb); @@ -1390,8 +1395,6 @@ static void rtl8139_hw_start (struct net_device *dev) RTL_W32 (RxConfig, tp->rx_config); RTL_W32 (TxConfig, rtl8139_tx_config); - tp->cur_rx = 0; - rtl_check_media (dev, 1); if (tp->chipset >= CH_8139B) { @@ -1406,9 +1409,6 @@ static void rtl8139_hw_start (struct net_device *dev) /* Lock Config[01234] and BMCR register writes */ RTL_W8 (Cfg9346, Cfg9346_Lock); - /* init Rx ring buffer DMA address */ - RTL_W32_F (RxBuf, tp->rx_ring_dma); - /* init Tx buffer DMA addresses */ for (i = 0; i < NUM_TX_DESC; i++) RTL_W32_F (TxAddr0 + (i * 4), tp->tx_bufs_dma + (tp->tx_buf[i] - tp->tx_bufs)); -- cgit v1.2.3