From f10378fff658f61307496e0ae00095041725cf07 Mon Sep 17 00:00:00 2001 From: Markus Lidel Date: Thu, 23 Jun 2005 22:02:16 -0700 Subject: [PATCH] I2O: new sysfs attributes and Adaptec specific block device access and 64-bit DMA support Changes: - Added Bus-OSM which could be used by user space programs to reset a channel on the controller - Make ioctl's in Config-OSM obsolete in prefer for sysfs attributes and move those to its own file - Added sysfs attribute for firmware read and write access for I2O controllers - Added special handling of firmware read and write access for Adaptec controllers - Added vendor id and product id as sysfs-attribute to Executive classes - Added automatic notification of LCT change handling to Exec-OSM - Added flushing function to Block-OSM for later barrier implementation - Use PRIVATE messages for Block access on Adaptec controllers, which are faster then BLOCK class access - Cleaned up support for Promise controller - New messages are now detected using the IRQ status register as suggested by the I2O spec - Added i2o_dma_high() and i2o_dma_low() functions - Added facility for SG tablesize calculation when using 32-bit and 64-bit DMA addresses - Added i2o_dma_map_single() and i2o_dma_map_sg() which could build the SG list for 32-bit as well as 64-bit DMA addresses Signed-off-by: Markus Lidel Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds --- drivers/message/i2o/Kconfig | 18 ++++++++++++++++++ 1 file changed, 18 insertions(+) (limited to 'drivers/message/i2o/Kconfig') diff --git a/drivers/message/i2o/Kconfig b/drivers/message/i2o/Kconfig index 8d132b0d6b12..ce278e060aca 100644 --- a/drivers/message/i2o/Kconfig +++ b/drivers/message/i2o/Kconfig @@ -35,6 +35,24 @@ config I2O_CONFIG To compile this support as a module, choose M here: the module will be called i2o_config. +config I2O_CONFIG_OLD_IOCTL + bool "Enable ioctls (OBSOLETE)" + depends on I2O_CONFIG + default y + ---help--- + Enables old ioctls. + +config I2O_BUS + tristate "I2O Bus Adapter OSM" + depends on I2O + ---help--- + Include support for the I2O Bus Adapter OSM. The Bus Adapter OSM + provides access to the busses on the I2O controller. The main purpose + is to rescan the bus to find new devices. + + To compile this support as a module, choose M here: the + module will be called i2o_bus. + config I2O_BLOCK tristate "I2O Block OSM" depends on I2O -- cgit v1.2.3