From 2ad52bdb220de5ab348098e3482b01235d15a842 Mon Sep 17 00:00:00 2001 From: Marijn Suijten Date: Tue, 6 Apr 2021 23:47:24 +0200 Subject: drm/msm/mdp5: Configure PP_SYNC_HEIGHT to double the vtotal Leaving this at a close-to-maximum register value 0xFFF0 means it takes very long for the MDSS to generate a software vsync interrupt when the hardware TE interrupt doesn't arrive. Configuring this to double the vtotal (like some downstream kernels) leads to a frame to take at most twice before the vsync signal, until hardware TE comes up. In this case the hardware interrupt responsible for providing this signal - "disp-te" gpio - is not hooked up to the mdp5 vsync/pp logic at all. This solves severe panel update issues observed on at least the Xperia Loire and Tone series, until said gpio is properly hooked up to an irq. Suggested-by: AngeloGioacchino Del Regno Signed-off-by: Marijn Suijten Reviewed-by: AngeloGioacchino Del Regno Link: https://lore.kernel.org/r/20210406214726.131534-2-marijn.suijten@somainline.org Signed-off-by: Rob Clark --- drivers/gpu/drm/msm/disp/mdp5/mdp5_cmd_encoder.c | 10 +++++++++- 1 file changed, 9 insertions(+), 1 deletion(-) (limited to 'drivers/gpu/drm/msm/disp/mdp5') diff --git a/drivers/gpu/drm/msm/disp/mdp5/mdp5_cmd_encoder.c b/drivers/gpu/drm/msm/disp/mdp5/mdp5_cmd_encoder.c index ff2c1d583c79..f6df4d3b1406 100644 --- a/drivers/gpu/drm/msm/disp/mdp5/mdp5_cmd_encoder.c +++ b/drivers/gpu/drm/msm/disp/mdp5/mdp5_cmd_encoder.c @@ -49,9 +49,17 @@ static int pingpong_tearcheck_setup(struct drm_encoder *encoder, | MDP5_PP_SYNC_CONFIG_VSYNC_IN_EN; cfg |= MDP5_PP_SYNC_CONFIG_VSYNC_COUNT(vclks_line); + /* + * Tearcheck emits a blanking signal every vclks_line * vtotal * 2 ticks on + * the vsync_clk equating to roughly half the desired panel refresh rate. + * This is only necessary as stability fallback if interrupts from the + * panel arrive too late or not at all, but is currently used by default + * because these panel interrupts are not wired up yet. + */ mdp5_write(mdp5_kms, REG_MDP5_PP_SYNC_CONFIG_VSYNC(pp_id), cfg); mdp5_write(mdp5_kms, - REG_MDP5_PP_SYNC_CONFIG_HEIGHT(pp_id), 0xfff0); + REG_MDP5_PP_SYNC_CONFIG_HEIGHT(pp_id), (2 * mode->vtotal)); + mdp5_write(mdp5_kms, REG_MDP5_PP_VSYNC_INIT_VAL(pp_id), mode->vdisplay); mdp5_write(mdp5_kms, REG_MDP5_PP_RD_PTR_IRQ(pp_id), mode->vdisplay + 1); -- cgit v1.2.3