From ff1cb0ed716304e9f7835ecc5f12ad580b0637ea Mon Sep 17 00:00:00 2001 From: Charles Keepax Date: Wed, 16 Sep 2015 10:42:20 +0100 Subject: extcon: arizona: Use the micd_clamp for interrupts if it is available Currently we only use the microphone clamp IRQ if GPIO5 is being used as a second jack detection pin. But we should be using it on any system where the clamp is available. This patch updates the driver to do so. Signed-off-by: Charles Keepax Signed-off-by: Chanwoo Choi --- drivers/extcon/extcon-arizona.c | 6 +++--- 1 file changed, 3 insertions(+), 3 deletions(-) (limited to 'drivers/extcon') diff --git a/drivers/extcon/extcon-arizona.c b/drivers/extcon/extcon-arizona.c index ece5892824d1..9255c1f1f285 100644 --- a/drivers/extcon/extcon-arizona.c +++ b/drivers/extcon/extcon-arizona.c @@ -1057,7 +1057,7 @@ static irqreturn_t arizona_jackdet(int irq, void *data) mutex_lock(&info->lock); - if (arizona->pdata.jd_gpio5) { + if (info->micd_clamp) { mask = ARIZONA_MICD_CLAMP_STS; present = 0; } else { @@ -1504,7 +1504,7 @@ static int arizona_extcon_probe(struct platform_device *pdev) pm_runtime_idle(&pdev->dev); pm_runtime_get_sync(&pdev->dev); - if (arizona->pdata.jd_gpio5) { + if (info->micd_clamp) { jack_irq_rise = ARIZONA_IRQ_MICD_CLAMP_RISE; jack_irq_fall = ARIZONA_IRQ_MICD_CLAMP_FALL; } else { @@ -1609,7 +1609,7 @@ static int arizona_extcon_remove(struct platform_device *pdev) ARIZONA_MICD_CLAMP_CONTROL, ARIZONA_MICD_CLAMP_MODE_MASK, 0); - if (arizona->pdata.jd_gpio5) { + if (info->micd_clamp) { jack_irq_rise = ARIZONA_IRQ_MICD_CLAMP_RISE; jack_irq_fall = ARIZONA_IRQ_MICD_CLAMP_FALL; } else { -- cgit v1.2.3