From 610fdd668e6af48fcae7908161d14eee3a95ec92 Mon Sep 17 00:00:00 2001 From: Aidan MacDonald Date: Thu, 23 Jun 2022 22:14:12 +0100 Subject: regmap-irq: Remove an unnecessary restriction on type_in_mask Check types_supported instead of checking type_rising/falling_val when using type_in_mask interrupts. This makes the intent clearer and allows a type_in_mask irq to support level or edge triggers, rather than only edge triggers. Update the documentation and comments to reflect the new behavior. This shouldn't affect existing drivers, because if they didn't set types_supported properly the type buffer wouldn't be updated. Signed-off-by: Aidan MacDonald Link: https://lore.kernel.org/r/20220623211420.918875-5-aidanmacdonald.0x0@gmail.com Signed-off-by: Mark Brown --- drivers/base/regmap/regmap-irq.c | 19 ++++++++----------- 1 file changed, 8 insertions(+), 11 deletions(-) (limited to 'drivers/base/regmap') diff --git a/drivers/base/regmap/regmap-irq.c b/drivers/base/regmap/regmap-irq.c index dca27b4e29d3..fd7c4315d16b 100644 --- a/drivers/base/regmap/regmap-irq.c +++ b/drivers/base/regmap/regmap-irq.c @@ -252,22 +252,19 @@ static void regmap_irq_enable(struct irq_data *data) struct regmap *map = d->map; const struct regmap_irq *irq_data = irq_to_regmap_irq(d, data->hwirq); unsigned int reg = irq_data->reg_offset / map->reg_stride; - unsigned int mask, type; - - type = irq_data->type.type_falling_val | irq_data->type.type_rising_val; + unsigned int mask; /* * The type_in_mask flag means that the underlying hardware uses - * separate mask bits for rising and falling edge interrupts, but - * we want to make them into a single virtual interrupt with - * configurable edge. + * separate mask bits for each interrupt trigger type, but we want + * to have a single logical interrupt with a configurable type. * - * If the interrupt we're enabling defines the falling or rising - * masks then instead of using the regular mask bits for this - * interrupt, use the value previously written to the type buffer - * at the corresponding offset in regmap_irq_set_type(). + * If the interrupt we're enabling defines any supported types + * then instead of using the regular mask bits for this interrupt, + * use the value previously written to the type buffer at the + * corresponding offset in regmap_irq_set_type(). */ - if (d->chip->type_in_mask && type) + if (d->chip->type_in_mask && irq_data->type.types_supported) mask = d->type_buf[reg] & irq_data->mask; else mask = irq_data->mask; -- cgit v1.2.3