From b4d2ea2af95cb77e2f320e24da526280d4aa2f6b Mon Sep 17 00:00:00 2001 From: Linus Walleij <linus.walleij@linaro.org> Date: Mon, 8 May 2017 10:48:21 +0200 Subject: Revert "pinctrl: generic: Add bi-directional and output-enable" This reverts commit 8c58f1a7a4b6d1d723bf25fef9d842d5a11200d0. It turns out that applying these generic properties was premature: the properties used in the driver using this are of unclear electrical nature and the subject need to be discussed. Signed-off-by: Linus Walleij <linus.walleij@linaro.org> --- Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt | 2 -- 1 file changed, 2 deletions(-) (limited to 'Documentation') diff --git a/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt b/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt index 71a3c134af1b..f01d154090da 100644 --- a/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt +++ b/Documentation/devicetree/bindings/pinctrl/pinctrl-bindings.txt @@ -247,7 +247,6 @@ bias-bus-hold - latch weakly bias-pull-up - pull up the pin bias-pull-down - pull down the pin bias-pull-pin-default - use pin-default pull state -bi-directional - pin supports simultaneous input/output operations drive-push-pull - drive actively high and low drive-open-drain - drive with open drain drive-open-source - drive with open source @@ -260,7 +259,6 @@ input-debounce - debounce mode with debound time X power-source - select between different power supplies low-power-enable - enable low power mode low-power-disable - disable low power mode -output-enable - enable output on pin regardless of output value output-low - set the pin to output mode with low level output-high - set the pin to output mode with high level slew-rate - set the slew rate -- cgit v1.2.3