From 3a30ae6ef3cba29c83ca791bde0d06f182d5678d Mon Sep 17 00:00:00 2001 From: Richard Leitner Date: Mon, 11 Dec 2017 13:16:57 +0100 Subject: phylib: Add device reset delay support Some PHYs need a minimum time after the reset gpio was asserted and/or deasserted. To ensure we meet these timing requirements add two new optional devicetree parameters for the phy: reset-delay-us and reset-post-delay-us. Signed-off-by: Richard Leitner Reviewed-by: Geert Uytterhoeven Reviewed-by: Andrew Lunn Signed-off-by: David S. Miller --- Documentation/devicetree/bindings/net/phy.txt | 10 ++++++++++ 1 file changed, 10 insertions(+) (limited to 'Documentation') diff --git a/Documentation/devicetree/bindings/net/phy.txt b/Documentation/devicetree/bindings/net/phy.txt index c05479f5ac7c..72860ce7f610 100644 --- a/Documentation/devicetree/bindings/net/phy.txt +++ b/Documentation/devicetree/bindings/net/phy.txt @@ -55,6 +55,12 @@ Optional Properties: - reset-gpios: The GPIO phandle and specifier for the PHY reset signal. +- reset-delay-us: Delay after the reset was asserted in microseconds. + If this property is missing the delay will be skipped. + +- reset-post-delay-us: Delay after the reset was deasserted in microseconds. + If this property is missing the delay will be skipped. + Example: ethernet-phy@0 { @@ -62,4 +68,8 @@ ethernet-phy@0 { interrupt-parent = <&PIC>; interrupts = <35 IRQ_TYPE_EDGE_RISING>; reg = <0>; + + reset-gpios = <&gpio1 4 GPIO_ACTIVE_LOW>; + reset-delay-us = <1000>; + reset-post-delay-us = <2000>; }; -- cgit v1.2.3