From 1da177e4c3f41524e886b7f1b8a0c1fc7321cac2 Mon Sep 17 00:00:00 2001 From: Linus Torvalds Date: Sat, 16 Apr 2005 15:20:36 -0700 Subject: Linux-2.6.12-rc2 Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip! --- Documentation/filesystems/bfs.txt | 57 +++++++++++++++++++++++++++++++++++++++ 1 file changed, 57 insertions(+) create mode 100644 Documentation/filesystems/bfs.txt (limited to 'Documentation/filesystems/bfs.txt') diff --git a/Documentation/filesystems/bfs.txt b/Documentation/filesystems/bfs.txt new file mode 100644 index 000000000000..d2841e0bcf02 --- /dev/null +++ b/Documentation/filesystems/bfs.txt @@ -0,0 +1,57 @@ +BFS FILESYSTEM FOR LINUX +======================== + +The BFS filesystem is used by SCO UnixWare OS for the /stand slice, which +usually contains the kernel image and a few other files required for the +boot process. + +In order to access /stand partition under Linux you obviously need to +know the partition number and the kernel must support UnixWare disk slices +(CONFIG_UNIXWARE_DISKLABEL config option). However BFS support does not +depend on having UnixWare disklabel support because one can also mount +BFS filesystem via loopback: + +# losetup /dev/loop0 stand.img +# mount -t bfs /dev/loop0 /mnt/stand + +where stand.img is a file containing the image of BFS filesystem. +When you have finished using it and umounted you need to also deallocate +/dev/loop0 device by: + +# losetup -d /dev/loop0 + +You can simplify mounting by just typing: + +# mount -t bfs -o loop stand.img /mnt/stand + +this will allocate the first available loopback device (and load loop.o +kernel module if necessary) automatically. If the loopback driver is not +loaded automatically, make sure that your kernel is compiled with kmod +support (CONFIG_KMOD) enabled. Beware that umount will not +deallocate /dev/loopN device if /etc/mtab file on your system is a +symbolic link to /proc/mounts. You will need to do it manually using +"-d" switch of losetup(8). Read losetup(8) manpage for more info. + +To create the BFS image under UnixWare you need to find out first which +slice contains it. The command prtvtoc(1M) is your friend: + +# prtvtoc /dev/rdsk/c0b0t0d0s0 + +(assuming your root disk is on target=0, lun=0, bus=0, controller=0). Then you +look for the slice with tag "STAND", which is usually slice 10. With this +information you can use dd(1) to create the BFS image: + +# umount /stand +# dd if=/dev/rdsk/c0b0t0d0sa of=stand.img bs=512 + +Just in case, you can verify that you have done the right thing by checking +the magic number: + +# od -Ad -tx4 stand.img | more + +The first 4 bytes should be 0x1badface. + +If you have any patches, questions or suggestions regarding this BFS +implementation please contact the author: + +Tigran A. Aivazian -- cgit v1.2.3