From 9fef65443388a66a2c19835e2848a6ecf162710b Mon Sep 17 00:00:00 2001 From: Emmanuel Grumbach Date: Sun, 29 Oct 2017 11:51:07 +0200 Subject: mac80211: always update the PM state of a peer on MGMT / DATA frames The 2016 version of the spec is more generic about when the AP should update the power management state of the peer: the AP shall update the state based on any management or data frames. This means that even non-bufferable management frames should be looked at to update to maintain the power management state of the peer. This can avoid problematic cases for example if a station disappears while being asleep and then re-appears. The AP would remember it as in power save, but the Authentication frame couldn't be used to set the peer as awake again. Note that this issues wasn't really critical since at some point (after the association) we would have removed the station and created another one with all the states cleared. Signed-off-by: Emmanuel Grumbach Signed-off-by: Luca Coelho Signed-off-by: Johannes Berg --- net/mac80211/rx.c | 17 +++++------------ 1 file changed, 5 insertions(+), 12 deletions(-) diff --git a/net/mac80211/rx.c b/net/mac80211/rx.c index 70e9d2ca8bbe..b3cff69bfd66 100644 --- a/net/mac80211/rx.c +++ b/net/mac80211/rx.c @@ -1607,23 +1607,16 @@ ieee80211_rx_h_sta_process(struct ieee80211_rx_data *rx) /* * Change STA power saving mode only at the end of a frame - * exchange sequence. + * exchange sequence, and only for a data or management + * frame as specified in IEEE 802.11-2016 11.2.3.2 */ if (!ieee80211_hw_check(&sta->local->hw, AP_LINK_PS) && !ieee80211_has_morefrags(hdr->frame_control) && - !ieee80211_is_back_req(hdr->frame_control) && + (ieee80211_is_mgmt(hdr->frame_control) || + ieee80211_is_data(hdr->frame_control)) && !(status->rx_flags & IEEE80211_RX_DEFERRED_RELEASE) && (rx->sdata->vif.type == NL80211_IFTYPE_AP || - rx->sdata->vif.type == NL80211_IFTYPE_AP_VLAN) && - /* - * PM bit is only checked in frames where it isn't reserved, - * in AP mode it's reserved in non-bufferable management frames - * (cf. IEEE 802.11-2012 8.2.4.1.7 Power Management field) - * BAR frames should be ignored as specified in - * IEEE 802.11-2012 10.2.1.2. - */ - (!ieee80211_is_mgmt(hdr->frame_control) || - ieee80211_is_bufferable_mmpdu(hdr->frame_control))) { + rx->sdata->vif.type == NL80211_IFTYPE_AP_VLAN)) { if (test_sta_flag(sta, WLAN_STA_PS_STA)) { if (!ieee80211_has_pm(hdr->frame_control)) sta_ps_end(sta); -- cgit v1.2.3