From 307d114441f905e4576871ff28d06408a1af1a7e Mon Sep 17 00:00:00 2001 From: Jarkko Lavinen Date: Mon, 1 Dec 2008 13:14:06 -0800 Subject: i82875p_edac: fix overflow device resource setup When I do "modprobe i82875p_edac" on my Asus P4C800 MB on kernels 2.6.26 or later, the module load fails due to BAR 0 collision. On 2.6.25 the module loads just fine. The overflow device on the MB seems to be hidden and its resources are not allocated at normal PCI bus init. Log shows the missing resource problem: EDAC DEBUG: i82875p_probe1() PCI: 0000:00:06.0 reg 10 32bit mmio: [fecf0000, fecf0fff] pci 0000:00:06.0: device not available because of BAR 0 [0xfecf0000-0xfecf0fff] collisions EDAC i82875p: i82875p_setup_overfl_dev(): Failed to enable overflow device The patch below fixes this by calling pci_bus_assign_resources() after the overflow device is revealed and added to the bus. With this patch I am again able to load and use the module. Signed-off-by: Jarkko Lavinen Cc: Doug Thompson Cc: Jesse Barnes Cc: Alan Cox Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds --- drivers/edac/i82875p_edac.c | 1 + 1 file changed, 1 insertion(+) diff --git a/drivers/edac/i82875p_edac.c b/drivers/edac/i82875p_edac.c index e43bdc43a1bf..7f909972fecd 100644 --- a/drivers/edac/i82875p_edac.c +++ b/drivers/edac/i82875p_edac.c @@ -295,6 +295,7 @@ static int i82875p_setup_overfl_dev(struct pci_dev *pdev, "%s(): pci_bus_add_device() Failed\n", __func__); } + pci_bus_assign_resources(dev->bus); } *ovrfl_pdev = dev; -- cgit v1.2.3