From a065685d2f0b4bb69d0f64d2cd396a5c463db2a9 Mon Sep 17 00:00:00 2001 From: Linus Walleij Date: Mon, 13 Jun 2011 10:42:19 +0200 Subject: ARM: pxa: fix gpio_to_chip() clash with gpiolib namespace The PXA platform code has a static inline helper called gpio_to_chip which clashes with the gpiolib namespace if we try to expose the function with the same name from gpiolib, and it's still confusing even if we don't do that. So rename it to gpio_to_pxachip(). Reported-by: H Hartley Sweeten Cc: Eric Miao Signed-off-by: Linus Walleij Signed-off-by: Eric Miao --- arch/arm/plat-pxa/gpio.c | 10 +++++----- 1 file changed, 5 insertions(+), 5 deletions(-) diff --git a/arch/arm/plat-pxa/gpio.c b/arch/arm/plat-pxa/gpio.c index 48ebb9479b61..a11dc3670505 100644 --- a/arch/arm/plat-pxa/gpio.c +++ b/arch/arm/plat-pxa/gpio.c @@ -50,7 +50,7 @@ static inline void __iomem *gpio_chip_base(struct gpio_chip *c) return container_of(c, struct pxa_gpio_chip, chip)->regbase; } -static inline struct pxa_gpio_chip *gpio_to_chip(unsigned gpio) +static inline struct pxa_gpio_chip *gpio_to_pxachip(unsigned gpio) { return &pxa_gpio_chips[gpio_to_bank(gpio)]; } @@ -161,7 +161,7 @@ static int pxa_gpio_irq_type(struct irq_data *d, unsigned int type) int gpio = irq_to_gpio(d->irq); unsigned long gpdr, mask = GPIO_bit(gpio); - c = gpio_to_chip(gpio); + c = gpio_to_pxachip(gpio); if (type == IRQ_TYPE_PROBE) { /* Don't mess with enabled GPIOs using preconfigured edges or @@ -230,7 +230,7 @@ static void pxa_gpio_demux_handler(unsigned int irq, struct irq_desc *desc) static void pxa_ack_muxed_gpio(struct irq_data *d) { int gpio = irq_to_gpio(d->irq); - struct pxa_gpio_chip *c = gpio_to_chip(gpio); + struct pxa_gpio_chip *c = gpio_to_pxachip(gpio); __raw_writel(GPIO_bit(gpio), c->regbase + GEDR_OFFSET); } @@ -238,7 +238,7 @@ static void pxa_ack_muxed_gpio(struct irq_data *d) static void pxa_mask_muxed_gpio(struct irq_data *d) { int gpio = irq_to_gpio(d->irq); - struct pxa_gpio_chip *c = gpio_to_chip(gpio); + struct pxa_gpio_chip *c = gpio_to_pxachip(gpio); uint32_t grer, gfer; c->irq_mask &= ~GPIO_bit(gpio); @@ -252,7 +252,7 @@ static void pxa_mask_muxed_gpio(struct irq_data *d) static void pxa_unmask_muxed_gpio(struct irq_data *d) { int gpio = irq_to_gpio(d->irq); - struct pxa_gpio_chip *c = gpio_to_chip(gpio); + struct pxa_gpio_chip *c = gpio_to_pxachip(gpio); c->irq_mask |= GPIO_bit(gpio); update_edge_detect(c); -- cgit v1.2.3 From 8c568df9d7e9b40063f0a5d4235e3d28df88f92a Mon Sep 17 00:00:00 2001 From: Sven Neumann Date: Wed, 25 May 2011 13:37:31 +0200 Subject: ARM: pxa/raumfeld: adapt to upcoming hardware change The backlight control is going to change back to PWM in the upcoming Raumfeld Controller hardware revision. Signed-off-by: Sven Neumann Acked-by: Daniel Mack Signed-off-by: Eric Miao --- arch/arm/mach-pxa/raumfeld.c | 11 ++++++----- 1 file changed, 6 insertions(+), 5 deletions(-) diff --git a/arch/arm/mach-pxa/raumfeld.c b/arch/arm/mach-pxa/raumfeld.c index d130f77b6d11..8e5b3d8a86be 100644 --- a/arch/arm/mach-pxa/raumfeld.c +++ b/arch/arm/mach-pxa/raumfeld.c @@ -598,14 +598,15 @@ static void __init raumfeld_lcd_init(void) pxa_set_fb_info(NULL, &raumfeld_sharp_lcd_info); - /* Earlier devices had the backlight regulator controlled - * via PWM, later versions use another controller for that */ - if ((system_rev & 0xff) < 2) { + /* Hardware revision 2 has the backlight regulator controlled + * by an LT3593, earlier and later devices use PWM for that. */ + if ((system_rev & 0xff) == 2) { + platform_device_register(&raumfeld_lt3593_device); + } else { mfp_cfg_t raumfeld_pwm_pin_config = GPIO17_PWM0_OUT; pxa3xx_mfp_config(&raumfeld_pwm_pin_config, 1); platform_device_register(&raumfeld_pwm_backlight_device); - } else - platform_device_register(&raumfeld_lt3593_device); + } ret = gpio_request(GPIO_TFT_VA_EN, "display VA enable"); if (ret < 0) -- cgit v1.2.3 From a74fe1194b8da1dcee7529ba14999381bb9c25d9 Mon Sep 17 00:00:00 2001 From: Sven Neumann Date: Wed, 25 May 2011 13:37:32 +0200 Subject: ARM: pxa/raumfeld: display initialisation fixes The display requires some milliseconds between GPIO_TFT_VA_EN and GPIO_DISPLAY_ENABLE. Reorder initialisation to comply with the display spec. Also tune timings for better compliance with the spec. Signed-off-by: Sven Neumann Acked-by: Daniel Mack Signed-off-by: Eric Miao --- arch/arm/mach-pxa/raumfeld.c | 29 +++++++++++++++-------------- 1 file changed, 15 insertions(+), 14 deletions(-) diff --git a/arch/arm/mach-pxa/raumfeld.c b/arch/arm/mach-pxa/raumfeld.c index 8e5b3d8a86be..9caa5e5c8d94 100644 --- a/arch/arm/mach-pxa/raumfeld.c +++ b/arch/arm/mach-pxa/raumfeld.c @@ -573,10 +573,10 @@ static struct pxafb_mode_info sharp_lq043t3dx02_mode = { .xres = 480, .yres = 272, .bpp = 16, - .hsync_len = 4, + .hsync_len = 41, .left_margin = 2, .right_margin = 1, - .vsync_len = 1, + .vsync_len = 10, .upper_margin = 3, .lower_margin = 1, .sync = 0, @@ -596,30 +596,31 @@ static void __init raumfeld_lcd_init(void) { int ret; - pxa_set_fb_info(NULL, &raumfeld_sharp_lcd_info); - - /* Hardware revision 2 has the backlight regulator controlled - * by an LT3593, earlier and later devices use PWM for that. */ - if ((system_rev & 0xff) == 2) { - platform_device_register(&raumfeld_lt3593_device); - } else { - mfp_cfg_t raumfeld_pwm_pin_config = GPIO17_PWM0_OUT; - pxa3xx_mfp_config(&raumfeld_pwm_pin_config, 1); - platform_device_register(&raumfeld_pwm_backlight_device); - } - ret = gpio_request(GPIO_TFT_VA_EN, "display VA enable"); if (ret < 0) pr_warning("Unable to request GPIO_TFT_VA_EN\n"); else gpio_direction_output(GPIO_TFT_VA_EN, 1); + msleep(100); + ret = gpio_request(GPIO_DISPLAY_ENABLE, "display enable"); if (ret < 0) pr_warning("Unable to request GPIO_DISPLAY_ENABLE\n"); else gpio_direction_output(GPIO_DISPLAY_ENABLE, 1); + /* Hardware revision 2 has the backlight regulator controlled + * by an LT3593, earlier and later devices use PWM for that. */ + if ((system_rev & 0xff) == 2) { + platform_device_register(&raumfeld_lt3593_device); + } else { + mfp_cfg_t raumfeld_pwm_pin_config = GPIO17_PWM0_OUT; + pxa3xx_mfp_config(&raumfeld_pwm_pin_config, 1); + platform_device_register(&raumfeld_pwm_backlight_device); + } + + pxa_set_fb_info(NULL, &raumfeld_sharp_lcd_info); platform_device_register(&pxa3xx_device_gcu); } -- cgit v1.2.3 From 9c0de4947a44166b16f189aa56f34791e9d7f552 Mon Sep 17 00:00:00 2001 From: Daniel Mack Date: Wed, 25 May 2011 13:37:33 +0200 Subject: ARM: pxa/raumfeld: fix device name for codec ak4104 In commit f0fba2ad (ASoC: multi-component - ASoC Multi-Component Support), the name of the ak4104 codec driver was changed without amending the platform code which uses it as well. Signed-off-by: Daniel Mack Signed-off-by: Eric Miao --- arch/arm/mach-pxa/raumfeld.c | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) diff --git a/arch/arm/mach-pxa/raumfeld.c b/arch/arm/mach-pxa/raumfeld.c index 9caa5e5c8d94..2f37d43f51b6 100644 --- a/arch/arm/mach-pxa/raumfeld.c +++ b/arch/arm/mach-pxa/raumfeld.c @@ -659,10 +659,10 @@ static struct lis3lv02d_platform_data lis3_pdata = { #define SPI_AK4104 \ { \ - .modalias = "ak4104", \ - .max_speed_hz = 10000, \ - .bus_num = 0, \ - .chip_select = 0, \ + .modalias = "ak4104-codec", \ + .max_speed_hz = 10000, \ + .bus_num = 0, \ + .chip_select = 0, \ .controller_data = (void *) GPIO_SPDIF_CS, \ } -- cgit v1.2.3 From 512b7938fefd03d512463aa597a1216cf088dfe3 Mon Sep 17 00:00:00 2001 From: Jonathan Cameron Date: Mon, 6 Jun 2011 15:24:13 +0100 Subject: pcmcia: pxa2xx/vpac270: free gpios on exist rather than requesting Signed-off-by: Jonathan Cameron Acked-by: Marek Vasut Signed-off-by: Eric Miao --- drivers/pcmcia/pxa2xx_vpac270.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/pcmcia/pxa2xx_vpac270.c b/drivers/pcmcia/pxa2xx_vpac270.c index 712baab3c83d..e956f659089a 100644 --- a/drivers/pcmcia/pxa2xx_vpac270.c +++ b/drivers/pcmcia/pxa2xx_vpac270.c @@ -76,10 +76,10 @@ static int vpac270_pcmcia_hw_init(struct soc_pcmcia_socket *skt) static void vpac270_pcmcia_hw_shutdown(struct soc_pcmcia_socket *skt) { if (skt->nr == 0) - gpio_request_array(vpac270_pcmcia_gpios, + gpio_free_array(vpac270_pcmcia_gpios, ARRAY_SIZE(vpac270_pcmcia_gpios)); else - gpio_request_array(vpac270_cf_gpios, + gpio_free_array(vpac270_cf_gpios, ARRAY_SIZE(vpac270_cf_gpios)); } -- cgit v1.2.3