From 0ed64a4c8f5d53aaa6b20e7424b127be7392f700 Mon Sep 17 00:00:00 2001 From: Aaro Koskinen Date: Sun, 22 Mar 2015 17:37:55 +0200 Subject: staging: octeon-usb: use USB stack to turn on power Use USB stack to turn on the power bit. It will also do the necessary delays. Signed-off-by: Aaro Koskinen Signed-off-by: Greg Kroah-Hartman --- drivers/staging/octeon-usb/octeon-hcd.c | 19 +++++++++---------- 1 file changed, 9 insertions(+), 10 deletions(-) diff --git a/drivers/staging/octeon-usb/octeon-hcd.c b/drivers/staging/octeon-usb/octeon-hcd.c index 1f501ff34a62..30a96ff869e4 100644 --- a/drivers/staging/octeon-usb/octeon-hcd.c +++ b/drivers/staging/octeon-usb/octeon-hcd.c @@ -860,12 +860,6 @@ static int cvmx_usb_initialize(struct cvmx_usb_state *usb) cvmx_usb_write_csr32(usb, CVMX_USBCX_HCFG(usb->index), usbcx_hcfg.u32); } - /* - * 3. Program the port power bit to drive VBUS on the USB, - * USBC_HPRT[PRTPWR] = 1 - */ - USB_SET_FIELD32(CVMX_USBCX_HPRT(usb->index), - union cvmx_usbcx_hprt, prtpwr, 1); /* * Steps 4-15 from the manual are done later in the port enable @@ -3354,6 +3348,7 @@ static int octeon_usb_hub_control(struct usb_hcd *hcd, u16 typeReq, u16 wValue, struct octeon_hcd *priv = hcd_to_octeon(hcd); struct device *dev = hcd->self.controller; struct cvmx_usb_port_status usb_port_status; + struct cvmx_usb_state *usb = &priv->usb; int port_status; struct usb_hub_descriptor *desc; unsigned long flags; @@ -3531,7 +3526,14 @@ static int octeon_usb_hub_control(struct usb_hcd *hcd, u16 typeReq, u16 wValue, return -EINVAL; case USB_PORT_FEAT_POWER: dev_dbg(dev, " POWER\n"); - return -EINVAL; + /* + * Program the port power bit to drive VBUS on the USB. + */ + spin_lock_irqsave(&priv->lock, flags); + USB_SET_FIELD32(CVMX_USBCX_HPRT(usb->index), + union cvmx_usbcx_hprt, prtpwr, 1); + spin_unlock_irqrestore(&priv->lock, flags); + return 0; case USB_PORT_FEAT_RESET: dev_dbg(dev, " RESET\n"); spin_lock_irqsave(&priv->lock, flags); @@ -3709,9 +3711,6 @@ static int octeon_usb_probe(struct platform_device *pdev) return -1; } - /* This delay is needed for CN3010, but I don't know why... */ - mdelay(10); - status = usb_add_hcd(hcd, irq, 0); if (status) { dev_dbg(dev, "USB add HCD failed with %d\n", status); -- cgit v1.2.3