| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
'err' is assigned but never read:
/drivers/clk/clk-si5341.c: In function ‘si5341_output_get_parent’:
drivers/clk/clk-si5341.c:886:6: warning: variable ‘err’ set but not used [-Wunused-but-set-variable]
Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Link: https://lore.kernel.org/r/20200916161740.14173-5-krzk@kernel.org
Signed-off-by: Stephen Boyd <sboyd@kernel.org>
|
|
Add support for the Si5342, Si5344 and Si5345 chips. These are equivalent
to the Si5341 family, but with more clock input options (which are not
supported yet by this driver).
Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
Link: https://lkml.kernel.org/r/20200507061544.11388-1-mike.looijmans@topic.nl
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Stephen Boyd <sboyd@kernel.org>
|
|
The Si5341 and Si5340 have multiple input clock options. So far, the driver
only supported the XTAL input, this adds support for the three external
clock inputs as well.
If the clock chip isn't programmed at boot, the driver will default to the
XTAL input as before. If there is no "xtal" clock input available, it will
pick the first connected input (e.g. "in0") as the input clock for the PLL.
One can use clock-assigned-parents to select a particular clock as input.
Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
Link: https://lkml.kernel.org/r/20200107075340.14528-1-mike.looijmans@topic.nl
Signed-off-by: Stephen Boyd <sboyd@kernel.org>
|
|
The variable n_den is initialized however that value is never read
as n_den is re-assigned a little later in the two paths of a
following if-statement. Remove the redundant assignment.
Addresses-Coverity: ("Unused value")
Signed-off-by: Colin Ian King <colin.king@canonical.com>
Link: https://lkml.kernel.org/r/20190701165020.19840-1-colin.king@canonical.com
Acked-by: Mike Looijmans <mike.looijmans@topic.nl>
Signed-off-by: Stephen Boyd <sboyd@kernel.org>
|
|
Adds a driver for the Si5341 and Si5340 chips. The driver does not fully
support all features of these chips, but allows the chip to be used
without any support from the "clockbuilder pro" software.
If the chip is preprogrammed, that is, you bought one with some defaults
burned in, or you programmed the NVM in some way, the driver will just
take over the current settings and only change them on demand. Otherwise
the input must be a fixed XTAL in its most basic configuration (no
predividers, no feedback, etc.).
The driver supports dynamic changes of multisynth, output dividers and
enabling or powering down outputs and multisynths.
Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
[sboyd@kernel.org: Mark some things static, use BIT_ULL for big bits and
ULL for big constants]
Signed-off-by: Stephen Boyd <sboyd@kernel.org>
|
