summaryrefslogtreecommitdiffstats
AgeCommit message (Expand)AuthorFilesLines
2012-10-24Bluetooth: trivial: Remove newline before EOFSyam Sidhardhan1-1/+0
2012-10-24Bluetooth: Start channel move when socket option is changedMat Martineau3-0/+25
2012-10-24Bluetooth: Do not retransmit data during a channel moveMat Martineau1-2/+2
2012-10-24Bluetooth: Ignore BR/EDR packet size constraints when fragmenting for AMPMat Martineau1-1/+3
2012-10-24Bluetooth: Configure appropriate timeouts for AMP controllersMat Martineau1-6/+41
2012-10-24Bluetooth: Do not send data during channel moveMat Martineau1-0/+12
2012-10-24Bluetooth: Flag ACL frames as complete for AMP controllersMat Martineau1-0/+9
2012-10-24Bluetooth: Handle physical link completionMat Martineau1-0/+164
2012-10-24Bluetooth: Add move confirm response handlingMat Martineau1-0/+18
2012-10-24Bluetooth: Add logical link confirmMat Martineau1-11/+123
2012-10-24Bluetooth: Move channel responseMat Martineau2-15/+170
2012-10-24Bluetooth: Add state to hci_chanMat Martineau2-0/+2
2012-10-24Bluetooth: Add move channel confirm handlingMat Martineau1-3/+55
2012-10-24Bluetooth: Add new ERTM receive states for channel moveMat Martineau1-0/+102
2012-10-24Bluetooth: Channel move request handlingMat Martineau1-1/+112
2012-10-24Bluetooth: Lookup channel structure based on DCIDMat Martineau1-0/+17
2012-10-23Bluetooth: Remove unnecessary intermediate functionMat Martineau1-11/+2
2012-10-23Bluetooth: Add L2CAP create channel request handlingMat Martineau1-15/+48
2012-10-23Bluetooth: Add new l2cap_chan struct members for high speed channelsMat Martineau2-0/+34
2012-10-19brcm80211: remove some truely barftastic codeAlan Cox2-40/+0
2012-10-19brcmfmac: remove 'always false' condition from brcmf_c_mkiovar_bsscfgArend van Spriel1-1/+1
2012-10-19brcmfmac: fix sparse warningsFranky Lin1-2/+2
2012-10-19brcmfmac: Using zero instead of NULLDan Carpenter1-4/+3
2012-10-19ath9k: perform ANI cycle in idle stateRajkumar Manoharan4-2/+16
2012-10-19carl9170: handle traps from firmware loaderChristian Lamparter2-3/+10
2012-10-19mwifiex: Using %*phD instead of print_hex_dump_bytesAndrei Emeltchenko1-12/+12
2012-10-19mwifiex: use sizeof(array) to print_hex_dump_bytesBing Zhao2-6/+7
2012-10-19rt2800: comment tx power settingsStanislaw Gruszka1-3/+19
2012-10-19rt2800: allow to reduce tx power on devices not exporting power limitStanislaw Gruszka1-0/+27
2012-10-19rt2800: pass channel pointer to rt2800_config_txpowerStanislaw Gruszka1-4/+5
2012-10-19rt2800: use eeprom OFDM 6M TX power as criterionStanislaw Gruszka1-5/+6
2012-10-19rt2800: compensate tx power also for non 11b rates on 2GHzStanislaw Gruszka1-3/+0
2012-10-19rt2800: limit TX_PWR_CFG_ values to 0xcStanislaw Gruszka1-1/+2
2012-10-19rt2800: use BBP_R1 for setting tx powerStanislaw Gruszka1-8/+19
2012-10-19ath_hw: Use common REG_WRITE parameter orderSven Eckelmann1-10/+10
2012-10-19rtlwifi: rtl8192ce: rtl8192cu: use %*phC to dump small buffersAndy Shevchenko3-13/+6
2012-10-19orinoco_usb: clean up some signedness issuesDan Carpenter1-5/+4
2012-10-19bcma: do not initialize deactivated PCIe coresHauke Mehrtens1-5/+5
2012-10-19ath/ath9k/ar9003_eeprom.c: Remove semicolon after ifPeter Senna Tschudin1-1/+1
2012-10-19ath9k: Fix BT_OP_SCAN usageSujith Manoharan1-9/+18
2012-10-19ath9k: Use a helper routine for MCI/FTP tuningSujith Manoharan1-12/+21
2012-10-19bcma: add an extra pcie core structHauke Mehrtens6-8/+31
2012-10-19bcma: use fallback sprom if sprom on card was not validHauke Mehrtens1-1/+4
2012-10-19ssb: add attribute to indicate a parallel flash is availableHauke Mehrtens2-0/+3
2012-10-19ssb: move parallel flash config into an own structHauke Mehrtens4-16/+19
2012-10-19bcma: add some more flash chips for serial flashHauke Mehrtens1-1/+30
2012-10-19bcma: extract drv_cc in bcma_core_mips_flash_detect()Hauke Mehrtens1-11/+12
2012-10-19bcma: mark nflash if it is the boot flashHauke Mehrtens2-0/+4
2012-10-19bcma: add and use constants for the flash windowsHauke Mehrtens3-5/+8
2012-10-19bcma: mark pflash as present when availableHauke Mehrtens2-0/+2