diff options
Diffstat (limited to 'Documentation')
| -rw-r--r-- | Documentation/admin-guide/kernel-parameters.txt | 5 | ||||
| -rw-r--r-- | Documentation/arm64/booting.txt | 5 | ||||
| -rw-r--r-- | Documentation/arm64/pointer-authentication.txt | 5 | ||||
| -rw-r--r-- | Documentation/arm64/silicon-errata.txt | 1 | ||||
| -rw-r--r-- | Documentation/devicetree/bindings/arm/pmu.txt | 70 | ||||
| -rw-r--r-- | Documentation/devicetree/bindings/arm/pmu.yaml | 87 |
6 files changed, 103 insertions, 70 deletions
diff --git a/Documentation/admin-guide/kernel-parameters.txt b/Documentation/admin-guide/kernel-parameters.txt index 49f2acc5eece..aa4f4cfd0491 100644 --- a/Documentation/admin-guide/kernel-parameters.txt +++ b/Documentation/admin-guide/kernel-parameters.txt @@ -1846,6 +1846,11 @@ to let secondary kernels in charge of setting up LPIs. + irqchip.gicv3_pseudo_nmi= [ARM64] + Enables support for pseudo-NMIs in the kernel. This + requires the kernel to be built with + CONFIG_ARM64_PSEUDO_NMI. + irqfixup [HW] When an interrupt is not handled search all handlers for it. Intended to get systems with badly broken diff --git a/Documentation/arm64/booting.txt b/Documentation/arm64/booting.txt index 8df9f4658d6f..fbab7e21d116 100644 --- a/Documentation/arm64/booting.txt +++ b/Documentation/arm64/booting.txt @@ -188,6 +188,11 @@ Before jumping into the kernel, the following conditions must be met: the kernel image will be entered must be initialised by software at a higher exception level to prevent execution in an UNKNOWN state. + - SCR_EL3.FIQ must have the same value across all CPUs the kernel is + executing on. + - The value of SCR_EL3.FIQ must be the same as the one present at boot + time whenever the kernel is executing. + For systems with a GICv3 interrupt controller to be used in v3 mode: - If EL3 is present: ICC_SRE_EL3.Enable (bit 3) must be initialiased to 0b1. diff --git a/Documentation/arm64/pointer-authentication.txt b/Documentation/arm64/pointer-authentication.txt index a25cd21290e9..5baca42ba146 100644 --- a/Documentation/arm64/pointer-authentication.txt +++ b/Documentation/arm64/pointer-authentication.txt @@ -78,6 +78,11 @@ bits can vary between the two. Note that the masks apply to TTBR0 addresses, and are not valid to apply to TTBR1 addresses (e.g. kernel pointers). +Additionally, when CONFIG_CHECKPOINT_RESTORE is also set, the kernel +will expose the NT_ARM_PACA_KEYS and NT_ARM_PACG_KEYS regsets (struct +user_pac_address_keys and struct user_pac_generic_keys). These can be +used to get and set the keys for a thread. + Virtualization -------------- diff --git a/Documentation/arm64/silicon-errata.txt b/Documentation/arm64/silicon-errata.txt index ddb8ce5333ba..d1e2bb801e1b 100644 --- a/Documentation/arm64/silicon-errata.txt +++ b/Documentation/arm64/silicon-errata.txt @@ -82,3 +82,4 @@ stable kernels. | Qualcomm Tech. | Falkor v1 | E1009 | QCOM_FALKOR_ERRATUM_1009 | | Qualcomm Tech. | QDF2400 ITS | E0065 | QCOM_QDF2400_ERRATUM_0065 | | Qualcomm Tech. | Falkor v{1,2} | E1041 | QCOM_FALKOR_ERRATUM_1041 | +| Fujitsu | A64FX | E#010001 | FUJITSU_ERRATUM_010001 | diff --git a/Documentation/devicetree/bindings/arm/pmu.txt b/Documentation/devicetree/bindings/arm/pmu.txt deleted file mode 100644 index 13611a8199bb..000000000000 --- a/Documentation/devicetree/bindings/arm/pmu.txt +++ /dev/null @@ -1,70 +0,0 @@ -* ARM Performance Monitor Units - -ARM cores often have a PMU for counting cpu and cache events like cache misses -and hits. The interface to the PMU is part of the ARM ARM. The ARM PMU -representation in the device tree should be done as under:- - -Required properties: - -- compatible : should be one of - "apm,potenza-pmu" - "arm,armv8-pmuv3" - "arm,cortex-a73-pmu" - "arm,cortex-a72-pmu" - "arm,cortex-a57-pmu" - "arm,cortex-a53-pmu" - "arm,cortex-a35-pmu" - "arm,cortex-a17-pmu" - "arm,cortex-a15-pmu" - "arm,cortex-a12-pmu" - "arm,cortex-a9-pmu" - "arm,cortex-a8-pmu" - "arm,cortex-a7-pmu" - "arm,cortex-a5-pmu" - "arm,arm11mpcore-pmu" - "arm,arm1176-pmu" - "arm,arm1136-pmu" - "brcm,vulcan-pmu" - "cavium,thunder-pmu" - "qcom,scorpion-pmu" - "qcom,scorpion-mp-pmu" - "qcom,krait-pmu" -- interrupts : 1 combined interrupt or 1 per core. If the interrupt is a per-cpu - interrupt (PPI) then 1 interrupt should be specified. - -Optional properties: - -- interrupt-affinity : When using SPIs, specifies a list of phandles to CPU - nodes corresponding directly to the affinity of - the SPIs listed in the interrupts property. - - When using a PPI, specifies a list of phandles to CPU - nodes corresponding to the set of CPUs which have - a PMU of this type signalling the PPI listed in the - interrupts property, unless this is already specified - by the PPI interrupt specifier itself (in which case - the interrupt-affinity property shouldn't be present). - - This property should be present when there is more than - a single SPI. - - -- qcom,no-pc-write : Indicates that this PMU doesn't support the 0xc and 0xd - events. - -- secure-reg-access : Indicates that the ARMv7 Secure Debug Enable Register - (SDER) is accessible. This will cause the driver to do - any setup required that is only possible in ARMv7 secure - state. If not present the ARMv7 SDER will not be touched, - which means the PMU may fail to operate unless external - code (bootloader or security monitor) has performed the - appropriate initialisation. Note that this property is - not valid for non-ARMv7 CPUs or ARMv7 CPUs booting Linux - in Non-secure state. - -Example: - -pmu { - compatible = "arm,cortex-a9-pmu"; - interrupts = <100 101>; -}; diff --git a/Documentation/devicetree/bindings/arm/pmu.yaml b/Documentation/devicetree/bindings/arm/pmu.yaml new file mode 100644 index 000000000000..52ae094ce330 --- /dev/null +++ b/Documentation/devicetree/bindings/arm/pmu.yaml @@ -0,0 +1,87 @@ +# SPDX-License-Identifier: GPL-2.0 +%YAML 1.2 +--- +$id: http://devicetree.org/schemas/arm/pmu.yaml# +$schema: http://devicetree.org/meta-schemas/core.yaml# + +title: ARM Performance Monitor Units + +maintainers: + - Mark Rutland <mark.rutland@arm.com> + - Will Deacon <will.deacon@arm.com> + +description: |+ + ARM cores often have a PMU for counting cpu and cache events like cache misses + and hits. The interface to the PMU is part of the ARM ARM. The ARM PMU + representation in the device tree should be done as under:- + +properties: + compatible: + items: + - enum: + - apm,potenza-pmu + - arm,armv8-pmuv3 + - arm,cortex-a73-pmu + - arm,cortex-a72-pmu + - arm,cortex-a57-pmu + - arm,cortex-a53-pmu + - arm,cortex-a35-pmu + - arm,cortex-a17-pmu + - arm,cortex-a15-pmu + - arm,cortex-a12-pmu + - arm,cortex-a9-pmu + - arm,cortex-a8-pmu + - arm,cortex-a7-pmu + - arm,cortex-a5-pmu + - arm,arm11mpcore-pmu + - arm,arm1176-pmu + - arm,arm1136-pmu + - brcm,vulcan-pmu + - cavium,thunder-pmu + - qcom,scorpion-pmu + - qcom,scorpion-mp-pmu + - qcom,krait-pmu + + interrupts: + # Don't know how many CPUs, so no constraints to specify + description: 1 per-cpu interrupt (PPI) or 1 interrupt per core. + + interrupt-affinity: + $ref: /schemas/types.yaml#/definitions/phandle-array + description: + When using SPIs, specifies a list of phandles to CPU + nodes corresponding directly to the affinity of + the SPIs listed in the interrupts property. + + When using a PPI, specifies a list of phandles to CPU + nodes corresponding to the set of CPUs which have + a PMU of this type signalling the PPI listed in the + interrupts property, unless this is already specified + by the PPI interrupt specifier itself (in which case + the interrupt-affinity property shouldn't be present). + + This property should be present when there is more than + a single SPI. + + qcom,no-pc-write: + type: boolean + description: + Indicates that this PMU doesn't support the 0xc and 0xd events. + + secure-reg-access: + type: boolean + description: + Indicates that the ARMv7 Secure Debug Enable Register + (SDER) is accessible. This will cause the driver to do + any setup required that is only possible in ARMv7 secure + state. If not present the ARMv7 SDER will not be touched, + which means the PMU may fail to operate unless external + code (bootloader or security monitor) has performed the + appropriate initialisation. Note that this property is + not valid for non-ARMv7 CPUs or ARMv7 CPUs booting Linux + in Non-secure state. + +required: + - compatible + +... |