Btrfs: add extra flushing for renames and truncates

Renames and truncates are both common ways to replace old data with new
data.  The filesystem can make an effort to make sure the new data is
on disk before actually replacing the old data.

This is especially important for rename, which many application use as
though it were atomic for both the data and the metadata involved.  The
current btrfs code will happily replace a file that is fully on disk
with one that was just created and still has pending IO.

If we crash after transaction commit but before the IO is done, we'll end
up replacing a good file with a zero length file.  The solution used
here is to create a list of inodes that need special ordering and force
them to disk before the commit is done.  This is similar to the
ext3 style data=ordering, except it is only done on selected files.

Btrfs is able to get away with this because it does not wait on commits
very often, even for fsync (which use a sub-commit).

For renames, we order the file when it wasn't already
on disk and when it is replacing an existing file.  Larger files
are sent to filemap_flush right away (before the transaction handle is
opened).

For truncates, we order if the file goes from non-zero size down to
zero size.  This is a little different, because at the time of the
truncate the file has no dirty bytes to order.  But, we flag the inode
so that it is added to the ordered list on close (via release method).  We
also immediately add it to the ordered list of the current transaction
so that we can try to flush down any writes the application sneaks in
before commit.

Signed-off-by: Chris Mason <chris.mason@oracle.com>

1 files changed, 18 insertions, 0 deletions

diff --git a/fs/btrfs/btrfs_inode.h b/fs/btrfs/btrfs_inode.h
index 3af4cfb5654c..b30986f00b9d 100644
--- a/fs/btrfs/btrfs_inode.h
+++ b/fs/btrfs/btrfs_inode.h
@@ -66,6 +66,12 @@ struct btrfs_inode {
 	 */
 	struct list_head delalloc_inodes;
 
+	/*
+	 * list for tracking inodes that must be sent to disk before a
+	 * rename or truncate commit
+	 */
+	struct list_head ordered_operations;
+
 	/* the space_info for where this inode's data allocations are done */
 	struct btrfs_space_info *space_info;
 
@@ -122,6 +128,18 @@ struct btrfs_inode {
 	 */
 	u64 last_unlink_trans;
 
+	/*
+	 * ordered_data_close is set by truncate when a file that used
+	 * to have good data has been truncated to zero.  When it is set
+	 * the btrfs file release call will add this inode to the
+	 * ordered operations list so that we make sure to flush out any
+	 * new data the application may have written before commit.
+	 *
+	 * yes, its silly to have a single bitflag, but we might grow more
+	 * of these.
+	 */
+	unsigned ordered_data_close:1;
+
 	struct inode vfs_inode;
 };